DOWNLOAD LG WD-10490NP Service Manual ↓ Size: 7.52 MB | Pages: 35 in PDF or view online for FREE

2-2.DETERMINE WASHING TIME BY FUZZY LOGIC

To get the best washing performance optimal time is determined by sensing of water temperature, 

selected washing temperature and laundry amount.

2-3.WATER LEVEL CONTROL

This model adopts a pressure sensor which can sense the water level in the tub.

When the water level reaches to the preset level the water supply is stopped, then the washing program proceeds.

Spinning does not proceed until the water in the tub reduces a certain level.

2-4.THE DOOR CAN NOT BE OPENED

While program is operating.

washing time

rinse time

spin rhythm, time

the best
washing
performance

SENSING

PROCESSING

DETERMINATION

EFFECT

3. PARTS IDENTIFICATION

Power plug

Control panel

Door

Lower cover

Adjustable feet

(For detergent and 

fabric softener)

Drawer

Drum

Lower cover cap

  If the supply cord is damaged,
  it must be replaced by the 

manufacturer or its service agents 
or a similarly qualified person in 
order to avoid a hazard.

Drain plug

Drain pump filter

ACCESSORIES

Before servicing ask the customer what the trouble is.
Check the adjustment (power supply is 220-240V, remove the transit bolts....)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly  instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O K or NOT.

STANDARD INSTALLATION

The appliance should be installed as follows.

REMOVE THE TRANSIT 

INSTALL THE  APPLIANCE

ADJUST THE 

BOLTS

ON FLAT AND FIRM SURFACE

HORIZONTAL

Remove the transit bolts

Turn the adjustable feet to

(4EA: ) with supplied wrench. 

set the appliance horizontally.

Keep the transit bolts and  

wrench for future use.

Insert the 4 caps provided 

into the hole.

The appliance goes up by 

rotating the feet clockwise. 

The appliance comes down by

rotating the feet counter-

clockwise.

4. INSTALLATION 

1

HOW TO CONNECT INLET HOSE

Check that the rubber washer is the inside of the

valve connector.

Connect inlet hose firmly to prevent leak.

CONNECT DRAIN HOSE

CONNECT POWER PLUG

Make sure that the hose is not twisted.

The drain hose should be placed under 100cm from the floor.

Connect the power plug to the wall outlet.

Avoid connecting several electric devices, 

It may be the cause of a fire.

Avoid submerging the end of the hose.