LG WD-10353NDK Service Manual ▷ View online
25
SPIN TROUBLE
While spinning, is the frequency of the
water level 248 or more?
Pressing QC test mode buttons at the
same time after power off, press the
START/PAUSE button 2 times, is the
drum low speed spin?
same time after power off, press the
START/PAUSE button 2 times, is the
drum low speed spin?
Is it disconnected, or disassembled?
[White : 3pin ( ), Red:3pin ( ),
Red:3pin ( ), National:4pin ( )]
[White : 3pin ( ), Red:3pin ( ),
Red:3pin ( ), National:4pin ( )]
Replace the PWB assembly.
Check the motor connector, Is the
resistance of the terminal same as the
figure?
MOTOR TERMINAL (1)
Resistance of terminal:
~ / ~ / ~ : About 5
Ω
~10
Ω
Check the sensor
(Pressure) or hose
(Sensor).
If the problem is on the
sensor or the hose,
replace the sensor or the
hose.
(Pressure) or hose
(Sensor).
If the problem is on the
sensor or the hose,
replace the sensor or the
hose.
Normal
Correct the connector.
Replace the STATOR
assembly.
YES
NO
NO
NO
YES
YES
NO
1
2
3
1
2
2
3
3
1
1
2
3
4
Is it disconnected, or disassembled?
White : 3pin( ), White:4pin( )]
White : 3pin( ), White:4pin( )]
Correct the connector.
NO
YES
1
2
YES
(1) (2)
1 2
3
4
26
9. DISASSEMBLY INSTRUCTIONS
Be sure to unplug the machine out of the outlet before disassembling and repairing the parts.
CONTROL PANEL
1
Unscrew 2 screws on the back of the top plate.
2
Pull the top plate backward and upward as shown.
1
Disconnect the PWB assembly connector from
Main lead wire assembly.
2
Pull out the drawer and unscrew 2 screws.
3
Push upper hooks down on the top and pull the
control panel.
1
Disconnect the PWB assembly (Main & Display)
from control panel by unscrewing 7 screws.
PLATE ASSEMBLY (TOP)
PANEL ASSEMBLY
(CONTROL)
Hook
27
1
Disassemble the top plate assembly.
2
Pull out the drawer to arrow direction.
3
Unscrew 2 screws.
1
The hose clamps and the hose are disassembled.
1
The ventilation bellows and the water inlet bellows
are disassembled on the tub.
DISPENSER ASSEMBLY
DISPENSER ASSEMBLY
PUSH
DRAWER
Option
28
INLET VALVE
1
Disconnect the wiring receptacle.
2
Unscrew 2 screws from the back.
When reconnecting the connector
LOWER COVER
Open the lower cover cap by using coin and pull
out the lower cover to the arrow direction after a
screw is unscrewed.
VALVE #1 (MAIN)
VALVE #2 (PRE)
VALVE #3 (HOT)
White / Black - Black
Gray / White - Black
Blue / Red - Black
DOOR
1
Open the door completely.
2
Remove the two screws from the hinge.
When removing the door assembly, it is
necessary to hold the bracket that is inner of
the cabinet cover.
necessary to hold the bracket that is inner of
the cabinet cover.
3
1
2
Click on the first or last page to see other WD-10353NDK service manuals if exist.