DOWNLOAD LG WD-10225FD Service Manual ↓ Size: 3.42 MB | Pages: 36 in PDF or view online for FREE

Disconnect the wiring connector.
Unscrew 2 screws from the back.

When reconnecting the connector

Cold only model

Cold and Hot model

Open the lower cover CAP by using coin and pull out

the lower cover in the arrow direction after a screw is
unscrewed.

1

2

3 Option

VALVE#1 (MAIN)

Whited/Black-Black

VALVE#2 (PRE)

Gray/ White - Black

VALVE #1 (MAIN)

Whited/Black-Black

VALVE #2 (PRE)

Gray/ White - Black

VALVE #3 (HOT)

Blue/Red - Black

Open the door completely.

Remove the two screws from the hinge.

When removing the DOOR ASSEMBLY, it is

necessary to hold the BRACKET that is inner of the

CABINET COVER.

Take apart the CLAMP ASSEMBLY (cabinet).

Unscrew 2 screws from the CABINET COVER.

Open the lower cover cap and unscrew 1 screw inside

Take apart the LOWER COVER.

Disassemble the CONTROL PANEL ASSEMBLY.

(Refer to page 26)

Unscrew all the screws on the upper and lower sides of

the CABINET COVER.

Take apart the tub CLAMP ASSEMBLY

Make sure that the drain hole of the GASKET is put

beneath when reassembling the GASKET.

Refer to the arrow mark on the TUB COVER.

Remove the BACK COVER.

Unscrew the bolt to pull out the ROTOR ASSEMBLY.

Disconnect the wiring connector.

Unscrew 6 bolts from the STATOR.

Remove the BODY FRAME.

(Only 1400 rpm models)

Note : Hook of connector (1) is on the backside

Pull out the HINGE, pressing its snap.
Do not use the pulled out HINGE again 

It may be taken off during operation.

Hinge

Damper

Rotor

Bolt

(1)

(ROTOR ASSEMBLY)

(STATOR ASSEMBLY)

(FRICTION DAMPER ASSEMBLY)

3

2

3

2

2. Unplug the drain plug ( ),

allowing the water to flow out. At
this time use a vessel to prevent
water flowing on to the floor. When
water does not flow any more, turn
the pump filter ( ) open to the left.

3. Remove any foreign material

from the pump filter ( ). After
cleaning, turn the pump filter ( )
clockwise and insert the drain
plug ( 

)to the original place.

close the lower cover cap.

1

100

1. Open the lower cover

cap ( ) by using a
coin. Turn the drain
plug ( ) to pull out
the hose.

Remove PUMP and CIRCULATION HOSE.

Remove BELLOWS..

Disconnect the wiring.

Unscrew 2 screws 

Remove the DRAIN PUMP ASSEMBLY.

Loosen the M6 heater nuts to pull out the HEATER

ASSEMBLY.

When mounting the HEATER ASSEMBLY be sure to

insert the HEATER ASSEMBLY into the heater clip on

the bottom of the tub.

Pull it out by holding the THERMISTOR bracket.

If it is pulled by the wire, it may be broken.

When mounting the THERMISTOR again, make sure

that it is got back tight to the bushing.

CAUTION