LG WD-10164SP Service Manual ▷ View online
Before servicing ask the customer what the trouble is.
Check the adjustment (power supply is 220-240V, remove the transit bolts....)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O Kor NOT.
Check the adjustment (power supply is 220-240V, remove the transit bolts....)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O Kor NOT.
STANDARD INSTALLATION
The appliance should be installed as follows.
REMOVE THE TRANSIT
INSTALL THE APPLIANCE
ADJUST THE
BOLTS
ON FLAT AND FIRM SURFACE
HORIZONTAL
Remove the transit bolts
Turn the adjustable feet to
(4EA: ) with supplied wrench.
set the appliance horizontally.
Keep the transit bolts and
wrench for future use.
Insert the 4 caps provided
into the hole.
into the hole.
The appliance goes up by
rotating the feet clockwise.
The appliance comes down by
rotating the feet counter-
clockwise.
clockwise.
4. INSTALLATION
7
1
High
Low
HOW TO CONNECT INLET HOSE
Check that the rubber washer is inside of the
valve connector.
Connect the inlet hose firmly to prevent leak.
CONNECT DRAIN HOSE
CONNECT POWER PLUG
8
Make sure that the hose is not twisted.
The drain hose should be placed under 100cm from the floor.
Connect the power plug to the wall outlet.
Avoid connecting several electric devices,
It may be the cause of a fire.
Avoid submerging the end of the hose.
TEST OPERATION
9
Connect the power plug to
In case of cotton program.
the outlet.
Connect the inlet hose.
Preparation for
Press the power button.
Press the START/PAUSE
washing.
button.
Check if the drum rotates
Check if water is supplied
clockwise and counterclockwise.
through the detergent dispenser.
Power off and then power on.
Check if the door can be
opened after 2 minutes.
Check if the door can be
opened after 2 minutes.
Press the Start/Pause button
after selecting Pump button by
pressing Program button.
after selecting Pump button by
pressing Program button.
If SVC is needed during
check, remove
the remaining water by pulling
out the hose cap.
Check the water heating.
Check automatic reverse
Check the water supply.
turn.
Check drain and spin
Power off and open the
Water removal
door
Click on the first or last page to see other WD-10164SP service manuals if exist.