LG T8000TE Service Manual ▷ View online
29
4-1. WIRING
DIAGRAM
4.SERVIC INFORMATION
30
4-2. PROGRAM TIME CHA
R T
31
4-3. ADJUSTMENT
1) Brake lever adjustment
• Shown as in the figure, untighten the adjustment
screw to keep clearance less than 1.9°æ0.1mm
between the tip and the brake lever.
And turn on the lock nut then paint it red.
• Painting part is adjusted in factory, it does not
need adjusting.
• Adjust the screw properly if the brake doesn't
work during spin.
CAUTION
2) Keeping clearance
• Keep the clearance about 2.0~3.5mm between
brake lever and P.V link as shown in the figure.
• Clutch pulley must be turning to one side P.V
Link is pulling the brake Lever.
• Clutch pulley must be turning to the left and the
right when P.V Linke does not pull the brake
Lever.
CAUTION
3) V-belt adjustment
• Adjust the motor pulley by pushing the motor like
arrow , to make V-belt tension parallel when
pushed at the point of arrow .
• When the V-belt is not properly adjusted, the
motor will not be running or the belt will be
slipping.
CAUTION
32
4-4. DISASSEMB
LY INSTRUCTION
Be sure to unplug the power to repair and
replace electric parts.
1) Disassembly of F ront Panel
& PCB Assembly
Remove two screw caps using a sharp tool
and two front panel fixing screws.
Push the front panel to the left side then
Push the front panel to the left side then
pull it out.
Disconnect the leads from the controller.
Remove 6 screw from the front panel.
Disconnect the leads from the controller.
Remove 6 screw from the front panel.
Remove the PCB Assembly.
Fuse is located in the PCB assembly For fuse
replacement use the following rated fuse
* Rating of fuse
- 250V 6A fusing type for 220-240V product
- 125V 12A fusing type for 100-127V product
Be sure to make earth connection for trouble
diagnosis and parts replacement. If impossible,
touch earth wire on the body to remove electric
deviation between the body and product before
work.
CAUTION FOR ELECTROSTATICS
H
D
W
Click on the first or last page to see other T8000TE service manuals if exist.