LG GCW1069LD Service Manual ▷ View online
24
Repair the DRAIN HOSE
ASSEMBLY.
ASSEMBLY.
Reconnect or repair the
connector
connector
Replace the DRAIN
PUMP ASSEMBLY.
PUMP ASSEMBLY.
Replace the MAIN PWB
ASSEMBLY.
ASSEMBLY.
Is the drain hose twisted or frozen?
Is the connector disconnected or disassembled?
Is the coil of the drain pump too high or low?
(resistance of the coil is 10-20 Ω)
(resistance of the coil is 10-20 Ω)
When checking voltage between connectors
(
and ) during drain, is the voltage 220 V AC
as in the figure?
OE ERROR (DRAIN TROUBLE)
25
Main washer
softener
Hose
PRESSURE S/W ASSEMBLY
Hose
PRESSURE S/W ASSEMBLY
Replace the INLET
VALVE ASSEMBLY.
※
※
Make sure the tap is closed
before replacing.
Replace the
PRESSURE S/W
ASSEMBLY.
Replace the
PRESSURE S/W
ASSEMBLY.
Is resistance between each terminal of INLET
VALVE ASSEMBLY 0.8~1.2k ?
Is water continuously supplied?
Is PRESSURE S/W ASSEMBLY broken?
Check electrical connection.
Replace the MAIN PWB ASSEMBLY.
Is PRESSURE S/W ASSEMBLY broken?
Check electrical connection.
Replace the MAIN PWB ASSEMBLY.
26
27
Have all the transit bolts and base packing
been removed?
Remove the transit bolts
and Base packing.
Move the washer or
reinforce the floor.
Is the washer installed on a solidly constructed
floor?
Check if the washer is perfectly level as follows:
Check the leveling of the washer with a level
and check that the washer is stable.
Put an unbalance part (rubber) inside of drum
and start QC test mode and run in high spin
(Refer to page 17)
When the machine is spinning in high speed,
verify that it is stable.
If it is not stable, adjust feet accordingly. After
the washer is level, tighten the lock nuts up
against of the base of the washer. All lock nuts
must be tightened.
If you do not have the unbalance part, put 4.5 to
6.5 lbs (2 to 3 kg) of clothing.
When the machine is spinning at high speed,
verify that it is stable.
Click on the first or last page to see other GCW1069LD service manuals if exist.