DOWNLOAD LG F74A8QDS Service Manual ↓ Size: 13.21 MB | Pages: 57 in PDF or view online for FREE

Is the drain hose kinked ?

Check drain hose for kink and straighten the 

.

Drain Hose

Is the 

clogged ?

Check & Clean 

.

This kind of accumulation on the drain filter not only
prevents proper drainage, but also will promote
bacteria growth and cause odors.
This drain filter should be cleaned once a month.

Open the Cover by coin or
finger(only new model)

Drain water by removing the
hose cap.

Disassemble the pump
filter by turning the filter
cap counterclockwise.

Filter clogged by foreign objects

Assemble & close cap

Clean the filter

Is the 

connected correctly to

the 

and the 

?

Or is the 

alright ?

Is the 

greater

than 1.0 m above the floor?

When there is no water in the
pump casing, is the water level
frequency over 26.0khz ?

Observe 

requirements 

of 

maximum.

- Your washer will not be able to drain out 

water adequately, if the standpipe exceeds 1.0 m.
In this case, water may flow back into the washer.

Check the 

and the 

(clogged).

Check the water level frequency again, if it is over
25.5KHz, replace the 

Reconnect or repair the 

.

Or replace the 

.

Replace the 

.

Replace the 

.

Is the resistance of the Pump Motor out
of range 152~175Ω?
Or is the Impeller operating normally?

Does the Pump motor start, when the spin mode
starts?

Clean the drain hose.

If the drain hose blocked?

OR

Power off for 10sec. Then power on.

Is the water level over reference line and is the water level frequency under 21.3kHz?

* Water level frequency

- Touch and Hold '

Pre Wash

' & '

Temp.

' 

simultaneously.

If FE is displayed again, 

then replace the 

.

If FE is displayed again, 

then replace the 

.

Drain out the water and then

check the 

and the 

(clogged).

Is water continuously

coming into the drawer?

Replace the 

Replace the 

assembly.

Data view type: ‘040’

Is the air chamber and the tube clogged?

Replace the 

.

Is the 

connected correctly to

the 

and the 

?

Is the 

alright ?

Reconnect or repair the 

.

Or replace the 

.

Check air chamber and remove foreign material.

Replace the 

.

Is the resistance of the 

out of range? 

[Pin1 ~ Pin3] 

Ω)