DOWNLOAD LG F1695RDH Service Manual ↓ Size: 14.72 MB | Pages: 69 in PDF or view online for FREE

MOTOR LOCKED

ERROR

• The connector in the LEAD WIRE ASSEMBLY is 

not connected to the connector of STATOR

ASSEMBLY.

Reconnect or repair the connector.

• The hall sensor is out of order/defective.

Replace the STATOR ASSEMBLY

Page 30

• Water leaks

Page 32

POWER 

FAILURE

WATER 

LEAKAGE

• The washer experienced a power failure

Press the start/pause button

• The Dry Heater is out of order

• The Connector of the Dry Heater is not connected

properly to the cinnector in the Main PWB ASSEMBLY

• The Dry fan motor is out of order

Page 33

DRY HEATER

ERROR

When you paused the machine under drying cycle, drying fan motor can be operated to save itself for 60

seconds.

7-7. TROUBLESHOOTING WITH ERROR CODES

Reconnect or repair the Connector.
Or replace the Harness.

Is the Connector connected correctly to the Main PCB
and the Inlet Valve? Is the Harness right?

Is the water tap closed?

[Note] Environmental safety check list

1. No water tap leakage or freeze       4. No entanglement of water supply hose.

2. No water shortage.                          5. No water supply hose leakage

3. The inlet filter is not cloggeed. 

Check the Water tap and  open it fully.

When there is water in the tub,
is the water level frequency
over 25.9kHz?

Are the inlet valve filters
clogged?

Check the Air Chamber and the Tube (clogged) 
Check the water level frequency again, 
if it is over 25.5kHz, replace the Pressure switch.

There are  filters on the unit’s inlet valves to filter mineral
deposits or other debris from entering the unit.
If it is clogged, water will not flow through these filters. Remove
hoses from unit, remove the filters and clean thoroughly.

 

 

 

Replace the Inlet Valve.

Replace the Main PCB.

Is the resistance of each lnlet valve within 3.5 ~4.5 kΩ ?

When the washing machine is started, is the inlet valve
operating?

Dry Valve

Pre Valve

Main Valve

Steam Valve (Option)

Clean nozzle Valve

3

3

1
2

5

4

1

2

5

4

Does the load lean toward one

side, or is the load a few items?

Is the washing machine installed

at an angle?

Adjust the height of washing

machine to be kept horizontally. 

( Page 7)

Is the laundry mixed?

The few items of clothing will clump together 

and their weight will be in one area of the drum,

throwing the weight off during spin mode.

Try rearranging the laundry in drum 

Or the laundry is separated by size, type, and color.

Separate by size, 

type and color

Is the drain hose kinked ?

Check drain hose for kink and straighten the hose.

Drain Hose

Is the Pump filter clogged ?

Check & Clean Pump Filter.

This kind of accumulation on the drain filter not only
prevents proper drainage, but also will promote
bacteria growth and cause odors.
This drain filter should be cleaned once a month.

Open the Cover 

Drain water by removing the

hose cap.

Disassemble the pump

filter by turning the filter

cap counterclockwise.

Filter clogged by foreign objects

Assemble & close cap

Clean the filter