LG F1443KD25 Service Manual ▷ View online
17
Select a water temperature based
on the type of load you are
washing.
By pressing the Rinse button, the
By pressing the Rinse button, the
Rinse type can be selected.
This display shows:
a) the estimated time remaining in the
cycle when operating.
To change the spin speed, turn the
spin knob to cycle through available
options.
EST. T ime remaining
Spin Selector knob
Tub Clean course can be set by
pressing and holding Rinse and
Temp button simultaneously.
Tub Clean is a special cycle to
clean the inside of the washer.
Tub Clean
Rinse, Temp. Button
In case of abnormal operation, error
indications are displayed.
(
)
¥ See troubleshooting
ing
am.
The Beep on/off function can be set by pressing
and holding the Option and Rinse button
simultaneouly.
Beep on/off
Use this option to prevent unwanted
use of the washer. Press and hold
Option left and right button for 3 seconds
to lock/unlock control.
When Child lock is set, CHILD LOCK
lights and all buttons are disabled
except the Power
button. You can
lock the washer while it is operating.
Child Lock
18
18
6. WIRING DIAGRAM / PCB LAYOUT / PROGRAM CHART
Wiring Diagram
19
PCB Layout (Main)
Earth Wire Connector
AG (Option)
AG SENSOR (Option)
20
Before servicing ask the customer what the trouble is.
Check the adjustments. (Power supply :220-240V~, Removal of transit bolts etc..)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works OK or NOT.
Check the adjustments. (Power supply :220-240V~, Removal of transit bolts etc..)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works OK or NOT.
7. TROUBLESHOOTING
7-1. CHECK BEFORE SERVICE
7-2. LOAD TEST MODE
1 Press and Hold ‘
Option (Right)
’ & ‘
Rinse
’ buttons
and then press ‘
Power
’ button.
2 The washer must be empty and the controls must be in the off state.
3 Press Power with above two buttons pressed and then buzzer will sound.
4 Press the Start/Pause button repeatedly to cycle through the test modes
F1443KDS2(1~9)
1
2
3
4
5
6
5
6
None
1 time
2 times
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times
11 times
12 times
13 times
14 times
Turns on all lights and locks the door.
Tumble clockwise.
Low speed Spin
High speed Spin
Inlet valve for prewash turns on.
Inlet valve for main wash turns on.
Inlet valve for hot water turns on.
Inlet valve for steam turns on.
Turmble counter clockwise
Heater turns on for 3 sec.
Circulation pump turns on.
Drain pump turns on.
Sensor for steam
Steam heater turns on for 1.2 sec.
Off
rpm (42~50)
rpm (60)
rpm (130~140)
Water level frequency
Water level frequency
Water level frequency
Water level frequency
rpm
Water temperature
Water level frequency
Water level frequency
Water level frequency
AG Temperature
-
Number of times the
Start/Pause button is pressed
Check Point
Display Status
Click on the first or last page to see other F1443KD25 service manuals if exist.