LG F1069FD6 / F1069FD7 Service Manual ▷ View online
25
-
OE ERROR (DRAIN TROUBLE)
Is displayed?
Is the drain pupm filter clogged with foreign
material such as pins, coins, etc?
material such as pins, coins, etc?
Is the coil of the drain pump too high or low?
(resistance of the coil is 10-20 Ω)
(resistance of the coil is 10-20 Ω)
When checking voltage between connectors
(
(
and
) during drain, is the voltage
AC 220 - 240 V, 50 Hz as in the figure?
Is the connector disconnected or disassembled?
Repair the DRAIN HOSE
ASSEMBLY.
Clean
the filter
the filter
Replace the DRAIN
PUMP ASSEMBLY.
PUMP ASSEMBLY.
Reconnect or repair the
connector
connector
Replace the MAIN PWB
ASSEMBLY.
Is the drain hose twisted or frozen?
26
FE ERROR
PE ERROR (PRESSURE S/W TROUBLE)
Is displayed?
Is displayed?
Is water contiunously supplied?
Is PRESSURE S/W ASSEMBLY broken?
Is PRESSURE S/W ASSEMBLY broken?
Check electrical connection.
Replace the MAIN PWB ASSEMBLY.
Replace the MAIN PWB ASSEMBLY.
Check electrical connection.
Replace the MAIN PWB ASSEMBLY.
Replace the MAIN PWB ASSEMBLY.
Replace the INLET
VALVE ASSEMBLY.
Make sure the tap is closed
before replacing.
before replacing.
Replace the PRESSURE
S/W ASSEMBLY.
Replace the PRESSURE
S/W ASSEMBLY.
Is resistance between each terminal of INLET
VALVE ASSEMBLY 0.8~1.2
VALVE ASSEMBLY 0.8~1.2
?
27
dE ERROR (DOOR ERROR)
28
Have all the transit bolts and base packing
been removed?
Remove the transit bolts
and Base packing.
Move the washer or
reinforce the floor.
Is the washer installed on a solidly constructed
floor?
Check if the washer is perfectly level as follows:
Check the leveling of the washer with a level
and check that the washer is stable.
Put an unbalance part (rubber) inside of drum
and start QC test mode and run in high spin
(Refer to page 17)
When the machine is spinning in high speed,
verify that it is stable.
If it is not stable, adjust feet accordingly. After
the washer is level, tighten the lock nuts up
against of the base of the washer. All lock nuts
must be tightened.
If you do not have the unbalance part, put 4.5 to
6.5 lbs (2 to 3 kg) of clothing.
When the machine is spinning at high speed,
verify that it is stable.
VIBRATION & NOISE IN SPIN
Click on the first or last page to see other F1069FD6 / F1069FD7 service manuals if exist.