LG DIRECT / DRIVE / 70140 Service Manual ▷ View online
30
Remove the BACK COVER.
Unscrew the bolt to pull out the ROTOR ASSEMBLY.
Disconnect the wiring connector.
Unscrew 6 bolts from the STATOR.
Remove the BODY FRAME.
(Only 1400 rpm models)
Note : Hook of connector (1) is on the backside
Pull out the HINGE, pressing its snap.
Do not use the pulled out HINGE again
Do not use the pulled out HINGE again
It may be taken off during operation.
Hinge
Damper
Rotor
Bolt
(1)
ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER ASSEMBLY
(ROTOR ASSEMBLY)
(STATOR ASSEMBLY)
(FRICTION DAMPER ASSEMBLY)
Clean the drain pump filter
3
2
3
2
2. Unplug the drain plug ( ),
allowing the water to flow out. At
this time use a vessel to prevent
water flowing on to the floor. When
water does not flow any more, turn
the pump filter ( ) open to the left.
this time use a vessel to prevent
water flowing on to the floor. When
water does not flow any more, turn
the pump filter ( ) open to the left.
3. Remove any foreign material
from the pump filter ( ). After
cleaning, turn the pump filter ( )
clockwise and insert the drain
plug (
cleaning, turn the pump filter ( )
clockwise and insert the drain
plug (
)to the original place.
close the lower cover cap.
1
100
1. Open the lower cover
cap ( ) by using a
coin. Turn the drain
plug ( ) to pull out
the hose.
coin. Turn the drain
plug ( ) to pull out
the hose.
31
Remove PUMP and CIRCULATION HOSE.
Remove BELLOWS..
Disconnect the wiring.
Unscrew 2 screws
Remove the DRAIN PUMP ASSEMBLY.
Loosen the M6 heater nuts to pull out the HEATER
ASSEMBLY.
When mounting the HEATER ASSEMBLY be sure to
insert the HEATER ASSEMBLY into the heater clip on
the bottom of the tub.
Pull it out by holding the THERMISTOR bracket.
If it is pulled by the wire, it may be broken.
When mounting the THERMISTOR again, make sure
that it is got back tight to the bushing.
DRAIN PUMP ASSEMBLY
HEATER ASSEMBLY
THERMISTOR
CAUTION
32
SWITCH ASSEMBLY, DOOR LOCK
WHEN FOREIGN MATERIAL IS STUCK BETWEEN DRUM AND TUB
Take apart the CLAMP ASSEMBLY (cabinet) and
release the GASKET.
Unscrew 2 screws holding the DOOR SWITCH
ASSEMBLY.
Disconnect the door lock from the wiring connector.
Remove the HEATER ASSEMBLY.
Remove the foreign material (wire, coin and others) by
inserting a long bar through the hole.
33
10-1.THE PART LIST OF CABINET ASSEMBLY
10. EXPLODED VIEW AND PART LIST
A103
A102
A104
A101
A100
A430
A485
A410
A140
A200
A201
A220
A303
A133
A275
A276
A440
A134
A130
A131
A141
A150
A154
A310
A300
A110
A152
A153
A151
HOT (RED)
COLD (BLUE)
A273
A274
A271
A272
A270
Click on the first or last page to see other DIRECT / DRIVE / 70140 service manuals if exist.