LG DIRECT / DRIVE / 70140 Service Manual ▷ View online
20
NO
YES
NO
NO
YES
NO
YES
YES
NO
NO
YES
YES
YES
NO
NO
NO
YES
Wiring diagram
Option (Hot)
Option (Hot)
MAX
max
Is water supply shut-off?
Is the tap opened?
When you press both Rinse button and Spin button
simultaneously, is the water level frequency below
240?
simultaneously, is the water level frequency below
240?
Is the inlet valve filter clogged with impurity?
Is resistance between each terminal of INLET
VALVE ASSEMBLY is 2~8
VALVE ASSEMBLY is 2~8
k
?
Check the voltage of the inlet valve connector
220 - 240V~.
(Refer to 7-2 QC TEST MODE)
Is water supplied?
Are replaceptacles correctly connected to the
terminals of the INLET VALVE ASSEMBLY?
terminals of the INLET VALVE ASSEMBLY?
Is detergent put in the correct compartment of
the drawer?
the drawer?
Is the detergent caked or hardened?
Open the tap.
Check the AIR CHAMBER
and the tube clogged
with impurity.
and the tube clogged
with impurity.
Clean the filter.
Replace the INLET VALVE
ASSEMBLY.
Replace the MAIN PWB
ASSEMBLY
Refer to
NO WATER SUPPLY
Check the wiring on the
dispenser.
Put the detergent in the
correct position
PRE+MAIN
MAIN WASH
: Detergent
Clean the drawer.
NO WATER SUPPLY
DETERGENT DOES NOT FLOW IN
21
YES
YES
NO
NO
NO
NO
YES
YES
YES
YES
Wiring diagram
Option (Hot)
MAX
max
ABNORMAL SOUND
SOFTENER DOES NOT FLOW IN
Fix the bolt tightly.
Replace the STATOR
ASSEMBLY or ROTOR
ASSEMBLY.
ASSEMBLY or ROTOR
ASSEMBLY.
Refer to
NO WATER SUPPLY
Check the wiring on the
dispenser.
dispenser.
Put it in the correct
compartment.
compartment.
Clean the cap and
drawer.
drawer.
Is the motor bolt loosened?
Is there friction noise from the motor?
Is water supplied?
Are receptacles correctly connected to the terminals
of the INLET VALVE ASSEMBLY?
of the INLET VALVE ASSEMBLY?
Is softener put in the correct compartment of the
drawer?
Is the softener cap clogged?
22
220-240V
NO
YES
YES
YES
YES
NO
NO
NO
NO
YES
YES
NO
MAIN PWB ASSEMBLY
MAIN PWB ASSEMBLY
2
1
Replace the
S.PRESSURE SWITCH
ASSEMBLY
Replace the MAIN PWB
ASSEMBLY
ASSEMBLY
Repair the DRAIN HOSE
ASSEMBLY.
Remove foreign material.
Reconnect or repair the
connector
Repair the DRAIN PUMP
ASSEMBLY.
Repair the MAIN PWB
ASSEMBLY.
When pressing Opt. 2 and Time Delay at the same
time after draining, is the water level frequency 252
or more? When pressing Opt. 2, Time Delay
buttons at the same time while wash, is the water
level frequency between
230 - 243 ?
time after draining, is the water level frequency 252
or more? When pressing Opt. 2, Time Delay
buttons at the same time while wash, is the water
level frequency between
230 - 243 ?
Checking voltage between two pins as press the
POWER button is the voltage 220 - 240V~?
POWER button is the voltage 220 - 240V~?
Is the drain hose twisted or frozen?
Is the impeller of the drain pump clogged?
Is the connector disconnected, disassembled?
Is the coil of the drain pump cut-off?
(resistance of coil is 90~160
)
When checking voltage between connectors
(
,
) on spinning, is the voltage 220 - 240V~
as the figure?
HEATING WITHOUT WATER
DRAIN MALFUNCTIONING
23
YES
YES
YES
YES
YES
NO
NO
NO
NO
NO
Hose
Connector
(Gray)
Connector
Connector
Hose
2
1
WILL NOT CIRCULATE WATER
Is the impeller of the drain pump clogged?
Are the Hose Connector and/or Hose clogged?
Is the connector disconnected, disassembled?
Is the coil of the right side of drain pump open
or short circuited? (Coil R is 18-30Ω)
or short circuited? (Coil R is 18-30Ω)
When checking voltage between the
connectors during spin, is the voltage
220-240V~ as the figure?
connectors during spin, is the voltage
220-240V~ as the figure?
Remove foreign material.
Remove foreign material.
Reconnect or repair
the connector.
the connector.
Replace PUMP MOTOR
ASSEMBLY.
ASSEMBLY.
Replace the MAIN PWB
ASSEMBLY.
ASSEMBLY.
Click on the first or last page to see other DIRECT / DRIVE / 70140 service manuals if exist.