LG 8144 / BJ Service Manual ▷ View online
28
PUMP CASE
1
3
2
PANEL ASSEMBLY, CONTROL
①
① Unscrew the 2 screws from upper of the canbinet
cover.
②
② Unscrew the screw from the pump case.
①
① Put a flat ( - ) screwdriver or putty knife into the both
sides of the pump case, and pull it out.
①
① Unscrew the screw from the lower side of the cabinet
cover.
①
① Unscrew the 2 screws from the lower of the DECO
PANEL.
①
① Two screws is unscrewed.
②
② Push out PANEL ASSEMBLY,CONTROL after Push
the hook(
①, ②
) below.
29
① The cabinet cover clamp is removed by
special jig for service and the gasket is
released.
released.
② Two screws are unscrewed.
①
Lift and separate the cabinet cover.
① The cabinet cover clamp is removed and the
gasket is released.
② Two screws are unscrewed.
③ The Door Lock S/W is disconnected form the
wiring connector and the strap.
SWITCH ASSY, DOOR LOCK
※
※ NOTE: When assembling the CABINET
COVER, connect the Door S/W connector.
30
① Remove the back cover.
② After loosening the bolt, Rotor, pull out the
rotor.
① Remove the 6 bolt from the stator.
② Disconnect the 2 connectors.
① Remove the hinges (Damper) at the Tub.
② The Hinge(Damper) at the base is pulled off
pressing on the snaps at the sharp end.
③ The hinge at the base is pulled off.
(To arrow direction)
ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER
Rotor
Bolt
Friction
Damper
Damper
Hinge
(Damper)
(ROTOR ASSEMBLY)
(STATOR ASSEMBLY)
(FRICTION DAMPER)
HOW TO ASSEMBLE THE MOTOR
TSG (TURBO STEAM GENERATOR)
① Remove the housing coupled the TSG
(Connector, Hoses, Earth Screw)
② Taking ou the screw of the TSG.
[WD-
❋❋❋❋❋FDS]
① Remove pump outlet hose.
② Remove tub pump bellows.
③ Remove cap(Remaining Hose).
④ Disconnect the wiring.
⑤ Three screws are unscrewed from the cabinet.
⑥ Remove the pump to arrow direction.
① Loosen the nut.
② Remove washing heater by pulling out.
When assembling the washing heater, insert
the heater to heater clip on the bottom of tub
and check the position of wire color.
the heater to heater clip on the bottom of tub
and check the position of wire color.
① Pull it out by holding the thermistor bracket.
If holding the wire and pulling out it, it may be
broken.
CAUTION
31
Washing
Heater
Wire Color:Red
Heater
Wire Color:Red
Wire Color:
Yellow
Nut
Ring Terminal
PUMP
HEATER
THERMISTOR
Click on the first or last page to see other 8144 / BJ service manuals if exist.