LG 40262 Service Manual ▷ View online
12
5. OPERATION
HOW TO USE
POWER (ON/OFF) BUTTON
Press to t urn t he washer ON. Press again to t urn
the washer OFF.
Press to t urn t he washer ON. Press again to t urn
the washer OFF.
NOTE: Pressing the POWER button during a
c ycle will cancel t hat cycle and any load
settings will be lost. The door will unlock after a
brief pause, unless the water level or
c ycle will cancel t hat cycle and any load
settings will be lost. The door will unlock after a
brief pause, unless the water level or
tempe rature is too high.
SPECIAL CYCLE AND OPTION BUT
These b
or options (refer to pages 22 and 23).
These b
or options (refer to pages 22 and 23).
TIME AND STATUS DISPLAY
The display shows the cycle status , door lock
The display shows the cycle status , door lock
status and est
page
page
DISPENSER DR
This drawer contains the compartments for
detergent and additi
and 18).
This drawer contains the compartments for
detergent and additi
and 18).
CYCLE SELECTOR KNOB
Turn this knob to select the desired cycle. Once the
Turn this knob to select the desired cycle. Once the
desired cycle has been selected, the standard presets
will appear in the display. These settings can b
will appear in the display. These settings can b
adjusted using the cycle setting buttons anytime
before starting the cycle (refer to pages 14 and 15).
START/ PAUSE BUTTON
Press this b
If the was her is running, use this button to pause
the cycle without losing the current settings.
Press this b
If the was her is running, use this button to pause
the cycle without losing the current settings.
NOTE: If you do not press the START/ PAUSE
button within four minutes of selecting a cycle,
the washer automatically turns OFF.
button within four minutes of selecting a cycle,
the washer automatically turns OFF.
CYCLE MODIFIER BUTTONS
Use these buttons to adjust the settings for the
Use these buttons to adjust the settings for the
selected cycle. The settings light up above the
buttons to show the current selection (refer to
page 20) .
buttons to show the current selection (refer to
page 20) .
CONTROL PANEL FEATURES
A
E
F
G
B
C
D
WARNING:
To reduce the risk o fire
f
electric shock, or injury to person , read and follow this
entire Use
&
C are Guide, including the Important Safety Instruct ions , before operating this washer.
NOTE: To protect your clothing, not all settings a
A
G
C
E
E
D
B
F
s
e
utton to start the selected cycle.
TONS
uttons are used to activate special cycles
imated time remaining ( refer t
o
19 ).
AWER
ves ( refer to pages 17
re available on all cycle selections ( refer to pages 14 and 15).
13
6. WIRING DIAGRAM/PROGRAM CHART
796.4026#9##
14
!" # #
$" !
%& #
'!( " "
! )*
! #! ! !#+ #!
BULKY/
LARGE
PERM.
PRESS
DELICATES
Normal
Extra Rinse
COTTON/
NORMAL
NORMAL
HAND WASH/
WOOL
SPEED
WASH
DRAIN+
SPIN
15
7-1. BEFORE PERFORMING SERVICE
■
Be careful of electric shock when disconnecting parts while troubleshooting.
■
The voltage of each terminal is 120 V AC and DC when the unit is plugged in.
7-2. QC TEST MODE.
The washer must be empty and the controls must be in the off state.
1. Press the SPIN SPEED and SOIL LEVEL buttons simultaneously.
2. Press the Power
1. Press the SPIN SPEED and SOIL LEVEL buttons simultaneously.
2. Press the Power
button, while the above condition. Then buzzer will sound twice.
3. Press the Start/Pause
buttonrepeatedly to cycle through the test modes.
4.
Alternate blinking of
,
and
7-3. HOW TO CHECK THE WATER LEVEL FREQUENCY
Press the Delay and Signal button simultaneously.
So, for example a display indicating 241: a Water level frequency of 241 x.1 kHz
= 24.1 kHz
The digits indicate the water level frequency ( x.1 kHz ).
s
u
t
a
t
S
y
a
l
p
s
i
D
t
n
i
o
P
k
c
e
h
C
None
Turns on all lamps and locks the door.
1 time
Tumble clockwise.
rpm (40~50)
m
p
r
.
n
i
p
S
d
e
e
p
s
w
o
L
s
e
m
it
2
m
p
r
.
n
i
p
S
d
e
e
p
s
h
g
i
H
s
e
m
it
3
4 times
4 times
Inlet valve for prewash turns on.
Water level frequency (25~65)
5 times
Inlet valve for main wash turns on.
Water level frequency (25~65)
6 times
Inlet valve for hot water turns on.
Water level frequency (25~65)
7 times
Inlet valve for bleach turns on.
Water level frequency (25~65)
8 times
Tumble counterclockwise.
rpm (40~50)
9 times
Water temperature (Thermistor)
Water temperature [°C]
10 times
Drainpump turns on.
Water level frequency (25~65)
11 times
Power off and unlock the door.
Turnoff all lamps.
Number of times the
Start/Pause buttonis pressed
7. TROUBLESHOOTING
Click on the first or last page to see other 40262 service manuals if exist.