LG 31513 Service Manual ▷ View online
25
4) Disassembly of Tub Cover and Pulsator
①
Remove 8 screws and take off the tub cover.
②
Remove the pulsator cap.
③
Remove the pulsator screws and take it out.
④
Remove the pulsator washer and take it out.
Tub Cover
Inner Tub Cap
Hub Fixing Nut
Outer Tub
Inner Tub
Inner Tub
Stator
Rotor Nut
Hub Attachment Nut
Shaft
Bearing Housing ASM
Rotor
Inner
Tub Cap
①
Hit the bar using the hammer. ②
Disconnect hub fixing nut and disassemble the inner tub.
5) Assemble the service tool (38 mm wrench)
6) Remove the hub attachment nut. (38 mm)
26
8) Disassembly of Rotor and Stator
①
Use a wrench (M24) to remove the nut that
connects the rotor to the shaft.
(The torque should be 200 kgf/cm or 88 foot-
pounds.)
②
Remove the rotor by pulling it straight off the
splined shaft.
7) Disassembly of Damper Assembly
① Remove the top cover of the washing machine.
② As shown in the drawing, lift the damper
assembly and remove it along with the outer
tub assembly.
tub assembly.
③ Damper assembly shall not be disassembled.
Replace damper as assembly.
6) Disassembly of the Back Cover and
Drain Pump
①
Remove the screws that attach the back cover and
take it off.
②
Disconnect the leads and the drain hose from the
drain pump.
③
Remove the pump attachment screws and the lead
connector. Take the pump assembly out of the
washer.
27
④
Disconnect the hall sensor and stator connection
before removing the stator in the subsequent step.
⑤
Remove the six screws securing the rotor.
⑥
Check the position of the snap ring, being sure it
faces the rotor and stator.
⑦
To keep from dropping the stator, loosen the six
bolts almost all the way; then hold the stator in one
hand while removing the bolts with the other.
⑧
Be careful during removal and replacement to avoid
cutting, nicking, or pinching any of the wires. This
could cause a short or electrical noise in the
machine.
③
Remove the screws that secure the water guide.
28
9) Disassembly of Door Lock Switch
①
Remove the two door lock attachment screws.
②
Remove the door switch and remove the attachment tube.
⑩
Remove 17 screws to release the bearing housing.
Pull the housing away from the tub, but do not pry it
with a screwdriver to avoid damage.
⑨
Remove four screws to release the tub bracket.
Bearing Housing
Click on the first or last page to see other 31513 service manuals if exist.