DOWNLOAD LG 3010 Service Manual ↓ Size: 4.45 MB | Pages: 41 in PDF or view online for FREE

(1)

(1)

(2)

Check the SENSOR SWITCH
ASSEMBLY or HOSE (Pressure). 
If the problem is on the SENSOR
SWITCH ASSEMBLY or the
HOSE, replace the SENSOR
SWITCH ASSEMBLY or the
HOSE.

Normal

Correct the connection.

Replace the STATOR
ASSEMBLY

Check during spin if the frequency of the water
level is 248 or more. 

When pressing Rinse, Spin, and Power buttons
at the same time after powerr, press the
START/PAUSE button 2 times in QC Test mode,
is the drum spinning at low speed?

Is it disconnected, or disassembled?
[Red: 3pin (1), NA: 4pin (2)]

Check the motor connector, Is the resistance of
the terminal the same as the figure?
MOTOR TERMINAL

Resistance of terminal: 

- / - / -

About 5 Ω 15 Ω

Replace the MAIN PWB ASSEMBLY

Does the spring of Latch Hook actuate?

Is there clicking sound once or twice when the
START/ PAUSE button is pressed to start the cycle?

Is DOOR SWITCH ASSEMBLY broken?

Replace Door Assembly.

Check the DOOR SWITCH
ASSEMBLY Connector and
MAIN PWB ASSEMBLY
(Red 3 pin, Yellow 4 pin and
white 3 pin connector (1)).

Replace the DOOR
SWITCH ASSEMBLY.

9. DISASSEMBLY INSTRUCTIONS

DISPLAY PWB ASSEMBLY

TOP PLATE ASSEMBLY

CONTROL PANEL ASSEMBLY

DRAWER

CONTROL PANEL ASSEMBLY

Be sure to unplug the machine out of the outlet before disassembling and repairing the parts. 

Unscrew 2 screws on the back of the top plate.

Pull the top plate backward and upward as shown.

Disconnect the Display PWB Assembly connector

from Trans cable.

Pull out the drawer and unscrew 2 screws.

Lift the left side of the Control Panel Assembly and

pull it out.

Unscrew the 9 screws from the Control Panel

Assembly.

Disassemble the Display PWB Assembly.

Disconnect the POWER connector and SENSOR

SWITCH ASSEMBLY.

Remove the Protect Cover.

Disconnect the connectors.

Unscrew 1 screw on the back.

Disassemble the Main PWB.

CONNECTOR

PROTECT COVER

MAIN PWB ASSEMBLY

Disassemble the top plate assembly.

Pull out the drawer.

Push out the DISPENSER ASSEMBLY after

unscrew 2 screws.

Unscrew the nut at the lower part of the dispenser.

Disassemble the 2 or 3 connectors from the valves.

Unscrew 2 or 4 screws from the back of the cabinet.

Unscrew a screw from the TOP BRACKET.

Disassemble two connectors from the POWER

CORD.

Wire Color

Blue Housing (BK-GR/WH)

White Housing (BK-WH/BK)

Red Housing (BK-BL/RD)

2

DISPENSER ASSEMBLY

NOISE FILTER