LG 60LM9600 (CHASSIS:LB23E) Service Manual ▷ View online
Circuit Block Diagram
▶
Tact Key Ass’y Picture
▶
LED+Sensor+IR Ass’y Picture
LED+Sensor+IR Ass’y
Tact Key Ass’y
■ New Sub Assy : Tact key(Above LM6400 Series)
* Motion Remote Controller
Remote
LS5700//LM6200(Dongle)
TV
UART or USB
RF
Pairing Information Transmission (Send to TV after Paired)
•
Static Calibration Data (Bypass only)
•
Remote FW ver. (Save also in Receiver)
•
BD_ADDR (Save also in Receiver)
•
Pairing Information Transmission Sequence
•
When it is paired, the remote sends packets(pairing success, F/W version, BD_ADDR) to the receiver.
•
The receiver sends the pairing success packet to TV directly.
•
F/W version and BD_ADDR packets are just saved on the receiver.
•
The receiver sends F/W version or BD_ADDR packet to TV when it is required.
Motion Data Transmission
•
Period : 7.5msec
•
Motion Data : gyro, accelerometer
Voice Data Transmission
( not supported )
•
Period : 10msec
•
Voice sampling : 16khz 16bit
See “6-2. Packets” on page 8.
LM6600//LM7600(Built in)
■ New Sub Assy : Magic Motion Remote Control(Above LM6400 Series)
* RF Pairing / Un-pairing Method
Method
Description
RF Pairing
Method1
–
If unpaired, just press "OK" button.
–
If paired, press "OK" button after
unpairing.
Method 2 (Repairing)
– Press “BACK" button for 5 sec.
•
When do pairing, the remote should make pairing
request IR signal(0x29) to TV.
•
When TV receive the IR signal, it should send "pairing
request packet" to the RF receiver.
•
After pairing success, the remote should blink LED for
some time and TV send "pairing success packet" back
to TV.
•
When remote try to unpairing, it doesn’t care about
state of receiver(stand alone).
RF Unpairing
Press “HOME" button and “BACK" button
at the same time for 5 sec.
•
When remote try to unpairing, it doesn’t care about
state of receiver(stand alone).
•
After unpairing, all pairing information should be erased.
•
After unpairing, LED should be blinked for 3sec.
•
The remote just becomes to IR mode.
■ New Sub Assy : Magic Motion Remote Control
주요 Item
IC
Manufacturer
Function
Remocon
Voice
Voice Codec
WM8950
Wolfson
16KHz Sampling of Audio data
MEMS Mic.
SPU0414HR5H
Knowles
Sensing Voice
Motion
Sensor
Gyro Sensor
ITG3050
Invensense
Sensing angular velocity of X, Y, Z-axis
Accelerometer
MMA8452
Stmicro
Sensing device tilt (Pitch & Roll angle)
RF
+
Micom
RF Antenna
SDBTPTR3015
Partron
Wireless communication
X-tal
24MHz
Partron
RF + Micom
BCM20733
Broadcom
DC-DC Converter
TPS61097
TI
Battery Boost up Regulator
LDO1
uPI7716
uPI
RF, Gyro, Accelerometer Power Supply
LDO2
uPI7716
uPI
Audio Codec, Mic. Power Supply
* Function list
Click on the first or last page to see other 60LM9600 (CHASSIS:LB23E) service manuals if exist.