LG MS-192H Service Manual ▷ View online
COMPONENTS
TEST PROCEDURE
RESULTS
5-11
TIMER MOTOR
(Wire leads removed)
(Wire leads removed)
Measure the resistance.
(Ohm-meter scale: R x 100)
(Ohm-meter scale: R x 100)
Measure the resistance.
(Ohm-meter scale: R x 1000)
(Ohm-meter scale: R x 1000)
Note: A is ON,OFF switch B is
power supply terminal of the
timer motor C is defrost switch
power supply terminal of the
timer motor C is defrost switch
NOTE : • A MICROWAVE LEAKAGE TEST MUST ALWAYS BE PERFORMED WHEN THE UNIT IS
SERVICED FOR ANY REASON.
• MAKE SURE THE WIRE LEADS ARE IN THE CORRECT POSITION.
• WHEN REMOVING THE WIRE LEADS FROM THE PARTS, BE SURE TO GRASP THE
• WHEN REMOVING THE WIRE LEADS FROM THE PARTS, BE SURE TO GRASP THE
CONNECTOR, NOT THE WIRES.
C
(2-3)
(2-3)
B
(2-M)
(2-M)
A
(1-2)
(1-2)
A
B
C
A
Turn on
Approx. 25 K
§
Turn Off
B
FAN MOTOR
(Wire leads removed)
(Wire leads removed)
TURNTABLE
MOTOR
(Wire leads removed)
MOTOR
(Wire leads removed)
Normal:
Abnormal:
∞
or several
Ω
Normal: Approx. 100~200
Ω
Abnormal:
∞
or several
Ω
A ~ B
A ~ C
30 ~ 50
Ω
300~500
Ω
5-12
TROUBLE SHOOTING
WHEN YOU GET A COMPLAINT FROM YOUR CUSTOMER, EVALUATE THE COMPLAINT CAREFULLY. IF
THE FOLLOWING SYMPTOMS APPLY, PLEASE INSTRUCT THE CUSTOMER IN THE PROPER USE OF THE
MICROWAVE OVEN. THIS CAN ELIMINATE AN UNNECESSARY SERVICE CALL.
THE FOLLOWING SYMPTOMS APPLY, PLEASE INSTRUCT THE CUSTOMER IN THE PROPER USE OF THE
MICROWAVE OVEN. THIS CAN ELIMINATE AN UNNECESSARY SERVICE CALL.
CAUTIONS
1. Check grounding before checking for trouble.
2. Be careful of the high voltage circuit.
3. Discharge the high voltage capacitor. (See page 2-1)
4. When checking the continuity of the switches or of the high voltage transformer, disconnect one lead wire
2. Be careful of the high voltage circuit.
3. Discharge the high voltage capacitor. (See page 2-1)
4. When checking the continuity of the switches or of the high voltage transformer, disconnect one lead wire
from these parts and then check continuity with the AC plug removed. To do otherwise may result in a
false reading or damage to your meter.
false reading or damage to your meter.
CONDITION
Microwave oven
does not work.
Inserting many plug into one
plug outlet and using
them at the same time
(causes overloading).
plug outlet and using
them at the same time
(causes overloading).
Microwave oven plug is not
inserted tightly.
inserted tightly.
Output power is too low.
Low AC input voltage.
Food temperature is too low.
Using metallic ware and
allowing it to touch the oven
wall.
allowing it to touch the oven
wall.
Sparks occur.
Inconsistent intensity of
microwave by their
characteristics.
microwave by their
characteristics.
1. Use plastic wrap or lid.
2. Stir once or twice while
2. Stir once or twice while
cooking soup, cocoa or
milk, etc.
milk, etc.
Uneven cooking.
Ceramic ware trimmed in
gold or silver powder is used.
gold or silver powder is used.
Avoid using other electrical
appliances when you use the
microwave oven.
appliances when you use the
microwave oven.
Insert microwave oven plug
securely.
securely.
Use the microwave oven at
adequate line voltage.
adequate line voltage.
This may not be a defect.
It is possible that the food
should be cooked for a
longer time period.
It is possible that the food
should be cooked for a
longer time period.
Do not use metallic ware for
cooking except where noted
in the cooking guide.
cooking except where noted
in the cooking guide.
Do not use any type of
cookware with metallic
trimming.
cookware with metallic
trimming.
CAUSE
REMEDY
Excessive weight on tray or
improperly balanced.
improperly balanced.
Distribute food evenly. Cook
smaller portions and,or use
lighter weight cookware.
smaller portions and,or use
lighter weight cookware.
Turntable drags or makes
noise.
noise.
5-13
CONDITION
CHECK
RESULT
CAUSE
REMEDY
1. Fuse blows.
Continuity.
No continuity.
Continuity.
Shorted contact at
the primary switch.
the primary switch.
Replace fuse,
primary, monitor
and secondary
switches.
primary, monitor
and secondary
switches.
No continuity.
Normal.
Defective high
voltage capacitor.
voltage capacitor.
Replace high
voltage capacitor.
voltage capacitor.
Fuse blows again
Defective high volt-
age transformer.
age transformer.
Replace high volt-
age transformer.
age transformer.
Malfunction of the
monitor switch.
monitor switch.
Replace fuse,
primary, monitor
and secondary
switches.
primary, monitor
and secondary
switches.
Check continuity
of monitor
switch (with
door closed).
of monitor
switch (with
door closed).
Check continuity
of primary
switch (with
door opened).
of primary
switch (with
door opened).
Disconnect one
side of the wire
lead connected
from transformer
to the high
voltage
capacitor and
operate the unit.
side of the wire
lead connected
from transformer
to the high
voltage
capacitor and
operate the unit.
Replace fuse
(TROUBLE 1) Oven lamp does not turn on when the timer knob is pushed with door closed.
NOTE : All these switches must be replaced at the same time.
This fuse is a special type of fuse which is kept as spare part by the importer.
5-14
(TROUBLE 3) Output power is low.
CONDITION
CHECK
RESULT
CAUSE
REMEDY
Output is low
Lower than 207V.
Normal
Less than 8.5
o
C.
Measure the
magnetron’s
output(See test
procedure).
magnetron’s
output(See test
procedure).
Faulty magnetron.
Replace.
Decrease in power
source voltage
with load.
source voltage
with load.
Suggest customer
contact local
electric power
utility co. or
qualified
electrician.
contact local
electric power
utility co. or
qualified
electrician.
Check the
power source
voltage
oscillating.
power source
voltage
oscillating.
No continuity.
No continuity.
replace.
Malfunction of the
timer switch.
timer switch.
Faulty thermostat.
replace.
Check the
continuity of the
timer switch
contacts.
continuity of the
timer switch
contacts.
Check the
continuity of the
thermostat.
continuity of the
thermostat.
1. Oven does not
operate.
No continuity.
No continuity.
Adjust or replace.
Malfunction of the
primary switch.
primary switch.
Malfunction of the
secondary switch.
secondary switch.
Adjust or replace.
Check the
continuity of the
primary switch
with door
closed.
continuity of the
primary switch
with door
closed.
Check the
continuity of the
secondary
switch with
secondary
switch pushed.
continuity of the
secondary
switch with
secondary
switch pushed.
(TROUBLE 2) Oven does not start even though the timer is set.
CONDITION
CHECK
RESULT
CAUSE
REMEDY
Click on the first or last page to see other MS-192H service manuals if exist.