DOWNLOAD LG MC-783RC Service Manual ↓ Size: 1.2 MB | Pages: 38 in PDF or view online for FREE

●

DO NOT operate on a 2-wire extension cord during
repair and use.

●

NEVER TOUCH any oven components or wiring
during operation .

●

BEFORE TOUCHING any parts of the oven, always
remove the power plug from the outlet.

●

For about 30 seconds after the oven stop, an electric
charge remains on the high voltage capacitor. When
replacing or checking, you must discharge the
capacitor by shorting across the two terminals with an
insulated screwdriver.

●

Remove your watches whenever working close to or
replacing the Magnetron.

●

NEVER operate the oven with no load.

●

NEVER damage the door seal or front plate of the
oven cavity.

●

NEVER put iron tools on the magnetron.

●

NEVER put anything into the latch hole and the
interlock switches area.

●

Proper operation of the microwave oven requires that
the magnetron be assembled to the waveguide and
cavity. Never operate the magnetron unless it is
properly installed.

●

Be sure that the magnetron gasket is properly installed
around the dome of the tube whenever installing the
magnetron .

5

Unlike other appliances, the microwave oven is
high-voltage and high-current appliance.

Though it is free from danger in ordinary use,
extreme care should be taken during repair.

Personnel should not be exposed to the microwave
energy which may radiate from the magnetron or
other microwave generating device if it is
improperly used or connected.

All input and output microwave connections,
waveguide,flange and gasket must be secure
never operate the device without a microwave
energy absorbing load attached.

Never look into an open waveguide or antenna
while the device is energized.

ANTENNA

GASKET

FILAMENT
TERMINAL

COOLING FIN

MAGNETRON

CHASSIS

GROUND

1. Empty the microwave oven and clean inside it with a

soft, damp cloth. Check for damage such as
misaligned door, damage around the door or dents
inside the cavity or on the exterior.

2. Put the oven on a counter, table or shelf that is

strong enough to hold the oven, food and utensils
you put in it. (The control panel side of the oven is
the heavy side. Use care when handling.)

3. Do not block the vent and the air intake openings.

Blocking vent or air intake openings can cause
damage to the oven and poor cooking results.
Make sure the microwave oven legs are in place to 
ensure proper air flow.

4. The oven should not be installed in any area where

heat and steam are generated, because they may
damage the electronic or mechanical parts of the
unit.
Do not install the oven next to a conventional
surface unit or above a conventional wall oven.

5. Use the microwave oven in an ambient temperature

of less than 104¡F (40¡C).

6. Place the microwave oven on a sturdy and flat

surface, at least 10cm(4 inches) from the wall.

7. Place the microwave oven as far away as possible

from TV, RADIO, COMPUTER etc, to prevent
interference.

8. This oven must be plugged into a 15A outlet.

9. Do not touch the front glass during or after cooking

of the Grill, Convection and Combination mode.
This glass is very hot during heater operating.

10. Do not operate oven at microwave and combination

mode with the Convection rack or Grill rack placed 
in the cavity when the oven is empty.

This microwave oven is designed to be used in a fully
earthed condition.
It is imperative, therefore, to make sure it is properly
earthed before servicing.

As the colours of the wires in the mains lead of this

appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed
as follows.

The wire which is coloured green-and-yellow must be
connected to the terminal in the plug which is marked
with the letter E or by the earth symbol (b

b) or coloured

green or green-and yellow.

The wire which is coloured blue must be connected to
the terminal in the plug which is marked with the letter N
or coloured black.

The wire which is coloured brown must be connected to
the terminal in the plug which is marked with the letter L
or coloured red.

6

The wires in this mains lead are coloured in
accordance with the following code:

8

The following is a description of component functions
during oven operation.

PLUG THE POWER

CORD INTO AN

ELECTRIC OUTLET

CLOCK

SET THE

CORRECT

HOUR

SET THE

CORRECT

MINUTE

CLOCK

STOP/CLEAR

DESIRED

POWER

LEVEL

DESIRED

COOKING

TIME

START

STOP/CLEAR

DESIRED

DEFROST

CATEGORY

DESIRED

COOKING

WEIGHT

START

DESIRED

POWER

LEVEL

DESIRED

COOKING

TIME

DESIRED

POWER

LEVEL

START

DESIRED

COOKING

TIME

Stage 1

Stage 2

GRILL OR

CONVECTION OR

COMBINATION

DESIRED

COOKING

TIME

STOP/CLEAR

DESIRED

COOKING

TIME

START

STOP/CLEAR

DESIRED

CONVECTION TEMP

(150¡C~200¡C)

START

GRILL

DESIRED

CONVECTION TEMP

(150¡C~250¡C)

GRILL

OR

START

DESIRED

COOKING

TIME

STOP/CLEAR

DESIRED

CONVECTION TEMP

(150¡C~250¡C)

START

DESIRED

COOKING

TIME

STOP/CLEAR

DESIRED

AUTO ROAST

CATEGORY

DESIRED

COOKING

WEIGHT

START

STOP/CLEAR

DESIRED

COOKING

WEIGHT

START

STOP/CLEAR

STOP/CLEAR

(Touch and Hold)

STOP/CLEAR

STOP/CLEAR

(Touch and Hold)

START

STOP/CLEAR

LESS

START

OR

PROGRAMME

DESIRED

AUTO COOK

STOP/CLEAR

MORE

DESIRED

AUTO COOK

CATEGORY

DESIRED POWER

LEVEL

(20%,40% or 60%)

OR

STOP/CLEAR

COMBINATION

¥ Function button touched.

Ñ

¥ Cooking stage changed.

Ñ  Ñ

¥ End of cooking

Ñ  Ñ  Ñ

¥ Error

Ñ  Ñ  Ñ

¥ Pass by half at auto weight defrost

Ñ  Ñ  Ñ  Ñ  Ñ

NOTE : Beep Sound
¥ The beep sound is activated under the following

condition.

This oven has a CHILD LOCK feature.

"L" appears on the display and you can't input any key.