DOWNLOAD JBL GTS 600 (serv.man2) Service Manual ↓ Size: 213.8 KB | Pages: 16 in PDF or view online for FREE

Model
GTS 600 (serv.man2)
Pages
16
Size
213.8 KB
Type
PDF
Document
User Manual / Operation Manual
Brand
Device
Car Audio
File
gts-600-sm2.pdf
Date
PREV: JBL GTS 600 Service Manual

JBL GTS 600 (serv.man2) User Manual / Operation Manual ▷ View online

Power On light is blinking,
indicating a fault condition,
and sound is intermittent or
off
Alternator whine through
the audio system with the
engine running
Bass output from speakers
too low
• Defective GTS300 or GTS600; If there is
audio signal present at the input of the
amplifier and there is no output, the
GTS300 or GTS600 may be defective.
• Incorrectly connected or shorted
speaker wires; check for shorts, frayed
wiring, damaged wiring insulation or
incorrect wiring.
• The speaker combination connected to
the amplifier is less than the minimum
requirement; reconfigure speaker
connection after consulting with section
3.1 “Speaker Requirements.”
• Amplifier is damaged; consult your JBL
Dealer.
• Ground loops; verify that the chassis
grounding point you have chosen is
true ground by checking for continuity
between the chassis ground point and
battery ground.
• Speaker wired out of phase; check for
proper polarity on all speaker wiring (+
amp terminal to + speaker terminal and
– amp terminal to – speaker terminal).
13
9. Specifications
Specifications
Power Output
(10Hz -50kHz,
14.4V Battery Voltage
Signal to Noise Ratio
Frequency Response
Damping Factor
Line Level Input Sensitivity
(For Rated Power)
Line Level Input
Impedance
Speaker Level Input
Impedance
Speaker Level Input
Sensitivity
Preamp Output Sensitivity
Minimum Speaker
Impedance
Single Ended
(Non-Bridged)
Bridged
Built in Electronic
Crossover Frequency
and Slope
Bass Boost Frequency
and Magnitude
14
GTS300
100 Watts x 2
(4 Ohms, 0.05% THD)
150 Watts x 2
(2 Ohms, 0.08% THD)
300 Watts x 1
(4 Ohms, 0.08% Thd)
100dBA
10Hz - 50kHZ (+0, -1dB)
20Hz - 20kHZ (+0, -0.1dB)
>200
100mV - 4V RMS
(500mV Nominal)
10k Ohms
200mV - 8V RMS
(2V Nominal)
1V out for 4V
Speaker Level Input
2 Ohms
4 Ohms
18dB per Octave Low Pass
Filter, Frequency Chips
Available from 50-5kHZ
18dB per Octave High Pass
Filter, Frequency Chips
Available from 50-5kHZ
4dB at 40Hz
GTS600
200 Watts x 2
(4 Ohms, 0.05% THD)
300 Watts x 2
(2 Ohms, 0.08% THD)
600 Watts x 1
(4 Ohms, 0.08% Thd)
100dBA
10Hz - 50kHZ (+0, -1dB)
20Hz - 20kHZ (+0, -0.1dB)
>200
100mV - 4V RMS
(500mV Nominal)
10k Ohms
200mV - 8V RMS
(2V Nominal)
1V out for 4V
Speaker Level Input
2 Ohms
4 Ohms
18dB per Octave Low Pass
Filter, Frequency Chips
Available from 50-5kHZ
18dB per Octave High Pass
Filter, Frequency Chips
Available from 50-5kHZ
4dB at 40Hz
15
Specifications
Power Requirement
Fuse Size
Size (L x W x H)
Weight
Speaker Level Input
Mating Connector
GTS300
11 to 16V DC
Negative Ground
40 Amp ATC Type Fuse
13 1/4”x 9 1/4”x 2”
(337 mm x 235 mm x
51 mm)
10 lbs 8.5 oz (4.8 Kg)
Molex Mini-Fit Jr.
# 39-01-2045-P
Metal Pins: 39-00-0039
GTS600
11 to 16V DC
Negative Ground
40 Amp ATC Type Fuse
(2 per Amplifier)
17 1/4”x 11 1/4”x 2”
(438 mm x 286 mm x
50.8 mm)
13 lbs 11.5 oz (6.2 Kg)
Molex Mini-Fit Jr.
# 39-01-2045-P
Metal Pins: 39-00-0039
16
DECLARATION OF CONFORMITY
Kongevejen 194B
DK-3460 Birkerød
DENMARK
declare that the product described in
this owner’s manual is in compliance
with technical standards:
EN 55020, EN 6.1988,
Accredited test laboratory:
MIKES PRODUCT SERVICE GmbH
Ohmstrasse 2-4
D-94342 Strasskirchen
GERMANY, (date tbd)
Steen Michaelsen
The appliance conforms with EEC
directive  87/308/EEC regarding
interference suppression
JBL Consumer Products, Inc.
80 Crossways Park West
Woodbury, NY 11799
A Harman International Company
Part No. JBL GTS100 OM
Page of 16
Display

JBL GTS 600 (serv.man2) User Manual / Operation Manual ▷ Download

Found More:

GTS 600 (serv.man2) Service Manuals

Preview DownloadPagesSize
GTS 600 Service Manual 27 2.1 MB

RANDOM: