JBL STUDIO 130 Service Manual ▷ View online
Release Date 2010 Discontinued Date XXXX
Technical Manual
STUDIO 130
AURAL-SWEEP TEST SPECIFICATIONS:
• System aural-sweep test:
• System aural-sweep test:
6.0V input 60Hz to 20kHz
• LF aural-sweep test:
5.0V input 60Hz to 4kHz
• HF aural-sweep test:
2.83V input 2kHz to 20kHz
PHYSICAL SPECIFICATIONS:
• Dimensions (W x H x D):
• Dimensions (W x H x D):
6-1/2" x 13-3/4" x 8-1/4"
(165mm x 349mm x 210mm)
• Weight:
21.8 lb (9.8kg) pair
WARRANTY:
• Refer to the warranty statement packed with the product.
• Refer to the warranty statement packed with the product.
* The maximum recommended amplifier power rating will
ensure proper system headroom to allow for occasional
peaks. We do not recommend sustained operation at these
maximum power levels.
STUDIO
130
11/10
ACOUSTIC & ELECTRICAL SPECIFICATIONS:
• Nominal impedance:
• Nominal impedance:
8 ohms
• Maximum amplifier power: 60W continuous; 240W peak*
• Frequency response:
• Frequency response:
60Hz – 22kHz
• Sensitivity:
87dB (2.83V/1m)
• Crossover frequency:
3kHz (12dB/octave)
SYSTEM COMPONENTS:
• Cabinet:
Studio 130 cabinet (not for sale)
• Top grille:
Studio 130 top grille
(244-040-05435-0BAE)
• Bottom grille:
Studio 130 bottom grille
(244-040-05436-0BAE)
• Low-frequency transducer: 4" (101mm) PolyPlas
™
cone,
shielded (10NR80BAK-FW04-1EP)
DC resistance:
4.7 ohms ±10%
• High-frequency transducer: 1" (25mm) CMMD
®
Lite dome,
shielded (36DT25BX-DT01-E)
DC resistance:
3.6 ohms ±10%
• Crossover network:
013-7600-05820-E
INPUT
+
–
LF
HF
L2: 0.27mH
L1: 1.2mH
L3
0.16mH
R1
2.7 ohms
10W
+
+
–
–
.250
.205
C1
4.3μF
100V
C1
3.3μF
100V
GREEN 200mm
BLACK 200mm
YELLOW 400mm
BLACK 400mm
RED 50mm
BLACK 50mm
.250
.205
.205
.110
STUDIO 130 WIRING DIAGRAM
24
24
20
19
22
23
21
Legend on Page 2
25
STUDIO 130 SCHEMATIC
PACKAGING
+
+
+
–
–
–
LOW-FREQUENCY
TRANSDUCER
10NR80BAK-FW04-1EP
CROSSOVER
NETWORK
013-7600-05820-E
HIGH-FREQUENCY
TRANSDUCER
36DT25BX-DT01-E
BLACK
BLACK
RED
BLACK
YELLOW
GREEN
Technical Manual
STUDIO 130
STUDIO
130
EXPLODED VIEW
HARMAN Consumer, Inc.
© 2010 HARMAN International Industries, Incorporated. All rights reserved. JBL and CMMD are trademarks of HARMAN International Industries, Incorporated,
registered in the United States and other countries. PolyPlas is a trademark of HARMAN International Industries, Incorporated.
Features, specifications and appearances are subject to change without notice.
11/10
TO SERVICE THE STUDIO 130:
Woofer: Remove the lower grille. Remove the four screws holding the woofer using a 2.5mm hex key (Allen wrench).
Tweeter: Remove both grilles. Remove all six grille cups in the plastic bezel with a needle-nosed pliers or similar tool. Remove all six bezel screws
using a 2.5mm hex key. Remove the plastic bezel by pulling it straight out. Remove the bar that attaches the tweeter to the bezel using a Phillips
screwdriver.
Tweeter: Remove both grilles. Remove all six grille cups in the plastic bezel with a needle-nosed pliers or similar tool. Remove all six bezel screws
using a 2.5mm hex key. Remove the plastic bezel by pulling it straight out. Remove the bar that attaches the tweeter to the bezel using a Phillips
screwdriver.
www.jbl.com
10
14
16
15
17
13
8
7
6
5
4
1
2
9
11
12
18
3
1 Not for Sale
Studio 130 Cabinet
1
(Black, Black w/Grain, Cherry)
2 013-7600-05820-E
Crossover Network/Terminal Cup
1
3 350-EM03520D082-E
Screws, Terminal Cup T3.5*20
4
4 10NR80BAK-FW04-1EP 4" Woofer
1
5 213-040-05225-0BAE
4" Trim Ring
1
6 350-KM03520D077-E
Screws, Woofer, T3.5*20
4
7 243-040-05280-0BAE
Plastic Bezel
1
8 214-036-05435-0BAE
Gasket, Tweeter
1
9 36DT25BX-DT01-E
1" Tweeter
1
10 398-ABS-05062-E
Plastic Bar, Tweeter
1
11 352-AM03512D121-E
Screws, Tweeter, T3.5*12
4
12 333-EVA-06007-0BAE
Gasket, Tweeter Bezel
1
13 350-KM03516D076-E
Screws, Bezel, T3.5*16
6
14 327-010-05055-0BAE
Grille Cup
8
15 316-AL-05412-0VAE
JBL
®
Logo
1
16 244-040-05435-0BAE Grille, Top
1
17 244-040-05436-0BAE Grille, Bottom
1
18 Not for Sale
Port Tube (Not Shown)
1
19 Visit www.jbl.com
Studio Series Owner’s Manual
1
20 Not for Sale
Plastic Bag
1
21 402-000-06482-E
Studio 130 Outer Carton, Cherry (CH)
1
402-000-06481-E
Studio 130 Outer Carton, Black w/Grain (BK) 1
402-000-06494-E
Studio 130 Outer Carton, Black
1
22 Not for Sale
Warranty Card
1
23 320-RUB-00504-E
Rubber Feet (set of 4)
2
24 431-000-07209-E
Foam, Top, Bottom
2
25 Not for Sale
Desiccant
2
ITEM
NO. PART NO.
DESCRIPTION
QTY.
ITEM
NO. PART NO.
DESCRIPTION
QTY.
Display