JBL ON BEAT RUMBLE (serv.man4) EMC - CB Certificate ▷ View online
Report No.: EM201200813-4
Application No.:
ZJ00024740
Page 33 of 53
For GFSK
Lowest Channels:
Middle Channels:
Report No.: EM201200813-4
Application No.:
ZJ00024740
Page 34 of 53
Highest Channels:
For 8DPSK
Lowest Channels:
Report No.: EM201200813-4
Application No.:
ZJ00024740
Page 35 of 53
Middle Channels:
Highest Channels:
Report No.: EM201200813-4
Application No.:
ZJ00024740
Page 36 of 53
4.5 HOPPING CHANNEL SEQUENCE
4.5.1 LIMITS
EN 300 328 clause 4.3.4.3.2
4.5.2 TEST PROCEDURE
Remove the antenna from the EUT and then connect a low attenuation cable from the antenna port to the
spectrum.
Set the spectrum analyzer: RBW = 100 kHz. VBW ≥ 100 kHz. Sweep = auto; Detector Function = Peak.
Trace = Max hold.
Allow the trace to stabilize. It may prove necessary to break the span up to sections. in order to clearly
show all of the hopping frequencies. The limit is specified in one of the subparagraphs of this Section.
Set the spectrum analyzer: start frequency = 2400MHz. stop frequency = 2483.5MHz. Submit the test
result graph.
4.5.3 TEST SETUP
EN 300 328 clause 4.3.4.3.2
4.5.2 TEST PROCEDURE
Remove the antenna from the EUT and then connect a low attenuation cable from the antenna port to the
spectrum.
Set the spectrum analyzer: RBW = 100 kHz. VBW ≥ 100 kHz. Sweep = auto; Detector Function = Peak.
Trace = Max hold.
Allow the trace to stabilize. It may prove necessary to break the span up to sections. in order to clearly
show all of the hopping frequencies. The limit is specified in one of the subparagraphs of this Section.
Set the spectrum analyzer: start frequency = 2400MHz. stop frequency = 2483.5MHz. Submit the test
result graph.
4.5.3 TEST SETUP
4.5.4 TEST RESULTS
Antenna
EUT
Receiver
Click on the first or last page to see other ON BEAT RUMBLE (serv.man4) service manuals if exist.