JBL ON BEAT MINI (serv.man2) EMC - CB Certificate ▷ View online
Page 24 of 99 Report No.: NTEK-2012DC1231016E
3.2.6 TEST PROCEDURE
a. The measuring distance of at 10 m shall be used for measurements at frequency up to 1GHz.
For frequencies above 1GHz, any suitable measuring distance may be used.
b. The EUT was placed on the top of a rotating table 0.8 meters above the ground at a 10 meter
open area test site. The table was rotated 360 degrees to determine the position of the highest
radiation.
radiation.
c. The height of the equipment or of the substitution antenna shall be 0.8 m; the height of the test
antenna shall vary between 1 m to 4 m. Both horizontal and vertical polarizations of the
antenna are set to make the measurement.
antenna are set to make the measurement.
d. The initial step in collecting conducted emission data is a spectrum analyzer peak detector
mode pre-scanning the measurement frequency range. Significant peaks are then marked and
then Quasi Peak detector mode re-measured, above 1G Average detector mode will be
instead.
then Quasi Peak detector mode re-measured, above 1G Average detector mode will be
instead.
e. If the Peak Mode measured value compliance with and lower than Quasi Peak Mode Limit, the
EUT shall be deemed to meet QP(AV) Limits and then no additional QP Mode measurement
performed.
performed.
f. For the actual test configuration, please refer to the related Item –EUT Test Photos.
Page 25 of 99 Report No.: NTEK-2012DC1231016E
3.2.7 TEST SETUP
(A) Radiated Emission Test Set-Up Frequency Below 1 GHz
(A) Radiated Emission Test Set-Up Frequency Below 1 GHz
B) Radiated Emission Test Set-Up Frequency Above 1GHz
Page 26 of 99 Report No.: NTEK-2012DC1231016E
(C) Disturbance Power Test Set-UP Frequency Below 1GHz
(D) Disturbance voltage at the antenna terminals
3.2.8 EUT OPERATING CONDITIONS
The EUT tested system was configured as the statements of 2.3 Unless otherwise a special
operating condition is specified in the follows during the testing.
The EUT tested system was configured as the statements of 2.3 Unless otherwise a special
operating condition is specified in the follows during the testing.
ANT IN
(75ohm)
(75ohm)
EUT
Matching
Transformer
Transformer
Signal
Generator
Generator
Matching
Transformer
Transformer
Spectrum
Page 27 of 99 Report No.: NTEK-2012DC1231016E
3.2.9 TEST RESULTS (30-1000MHz)
EUT:
Speaker dock for iPhone, iPad
and iPod
and iPod
Model Name :
JBL OnBeat Mini
Temperature:
24 ℃
Relative Humidity: 54%
Pressure:
1010 hPa
Test Date :
2013-01-07
Test Mode :
Mode 1
Polarization :
Horizontal
Test Power :
DC 13V From Adapter AC 230V/50Hz
Freq.
Reading
Factor
Measurement
Limit Over
(MHz)
(dBuV)
(dBuV)
(dBuV)
(dBuV)
(dB)
72.0843
27.92
6.37
34.29
40.00
-5.71
Peak
191.7450
28.61
8.99
37.60
40.00
-2.40
Peak
291.0360
21.14
14.45
35.59
47.00
-11.41
Peak
Detector
Remark:
1. All readings are Quasi-Peak and Average values.
2. Factor = Antenna Factor + Cable Loss.
3. N/A means All Data have pass Limit
1. All readings are Quasi-Peak and Average values.
2. Factor = Antenna Factor + Cable Loss.
3. N/A means All Data have pass Limit
Click on the first or last page to see other ON BEAT MINI (serv.man2) service manuals if exist.