JBL AUTHENTICS L8 (serv.man4) EMC - CB Certificate ▷ View online
Report No.: EM201300471-1 Application No.:
ZJ00032008 Page 49 of 57
3. Highest Channel: 2480MHz
30M-1000MHz Spurious Emissions Peak Measurement
No.
Frequency
Reading
Correct
Result
Limit
Margi
n
Remark
(MHz)
(dBm)
Factor(dB)
(dBm)
(dBm)
(dB)
1
122.9389 -76.78 18.80 -57.98 -36.00
-21.98
Vertical
2
160.1008 -78.46 20.69 -57.77 -36.00
-21.77
Vertical
3
221.7906 -87.34 22.58 -64.76 -36.00
-28.76
Vertical
4
269.9983 -85.79 24.15 -61.64 -36.00
-25.64
Vertical
5
319.5776 -86.94 26.20 -60.74 -36.00
-24.74
Vertical
6
418.5244 -89.53 28.32 -61.21 -36.00
-25.21
Vertical
7
110.4892 -85.71 19.46 -66.25 -36.00
-30.25
Horizontal
8
122.9389 -78.79 18.80 -59.99 -36.00
-23.99
Horizontal
9
160.1008 -81.41 20.69 -60.72 -36.00
-24.72
Horizontal
10
172.2345 -81.24 20.63 -60.61 -36.00
-24.61
Horizontal
11
269.9983 -84.68 24.15 -60.53 -36.00
-24.53
Horizontal
12
319.5776 -90.14 26.20 -63.94 -36.00
-27.94
Horizontal
1000MHz-12750MHz Spurious Emissions Peak Measurement
No.
Frequency
Reading
Correct
Result
Limit
Margi
n
Remark
(MHz)
(dBm)
Factor(dB)
(dBm)
(dBm)
(dB)
1
2756.891 -77.83 18.65 -59.18
-30.00
-29.18
Vertical
2
2865.769 -78.22 20.02 -58.20
-30.00
-28.20
Vertical
3
2932.117 -77.54 20.82 -56.72
-30.00
-26.72
Vertical
4
9675.495 -80.25 25.16 -55.09
-30.00
-25.09
Vertical
5
10915.382 -79.15 24.86 -54.29
-30.00
-24.29
Vertical
6
12428.904 -79.10 26.25 -52.85
-30.00
-22.85
Vertical
7
2675.600 -77.10 17.58 -59.52
-30.00
-29.52
Horizontal
8
2870.819 -78.94 20.08 -58.86
-30.00
-28.86
Horizontal
9
2937.283 -77.74 20.88 -56.86
-30.00
-26.86
Horizontal
10
9788.325 -80.33 25.34 -54.99
-30.00
-24.99
Horizontal
11
10252.954 -79.96 25.15 -54.81
-30.00
-24.81
Horizontal
12
12691.008 -79.57 27.11 -52.46
-30.00
-22.46
Horizontal
TX in standby Mode:
Since the spurious emission of the EUT is too weak to be detected.(≤-70dBm)
Report No.: EM201300471-1 Application No.:
ZJ00032008 Page 50 of 57
5. RECEIVER REQUIREMENTS
5.1 RECEIVER SPURIOUS EMISSIONS
5.1.1 LIMITS
Frequency range
Limit
30 MHz to 1 GHz
-57 dBm
above 1 GHz to 12,75 GHz
-47 dBm
5.1.2 TEST PROCEDURE
EIRP emission test method as below
1. The EUT shall operate on receive mode. And Interface cables, loads, and devices
should be connected to at least one of each type of the interface ports of the EUT and,
where practical, each cable shall be terminated in a device typical for its actual use.
EUT shall be placed at the 1.5m support on the turntable.
where practical, each cable shall be terminated in a device typical for its actual use.
EUT shall be placed at the 1.5m support on the turntable.
2. The test antenna at a horizontal distance of 3 m .It shall be raised and lowered from 1m
to 4m until a maximum signal level is detected by the measuring receiver. Then the
turntable should be rotated through 360° in the horizontal plane, until the maximum
signal level is detected by the measuring receiver. in both the vertical and the
horizontal polarization. Record the reading level, antenna position, polarization and
turntable position.
turntable should be rotated through 360° in the horizontal plane, until the maximum
signal level is detected by the measuring receiver. in both the vertical and the
horizontal polarization. Record the reading level, antenna position, polarization and
turntable position.
3. Remove the EUT and replace it with a substitution antenna (the antenna should be
half-wavelength for each frequency involved). The center of the substitution antenna
should be approximately at the same location as the center of the transmitter. For
frequencies of 80 MHz and above, the dipoles should have their arm lengths set for
resonance at the frequency of test. Below 80 MHz, shortened arm lengths are
recommended. For measurements above 1 000 MHz, a waveguide horn is
recommended. The centre of this antenna should coincide with either the phase centre
or volume centre.
should be approximately at the same location as the center of the transmitter. For
frequencies of 80 MHz and above, the dipoles should have their arm lengths set for
resonance at the frequency of test. Below 80 MHz, shortened arm lengths are
recommended. For measurements above 1 000 MHz, a waveguide horn is
recommended. The centre of this antenna should coincide with either the phase centre
or volume centre.
4. Feed the substitution antenna at the EUT end with a signal generator connected to the
antenna by a cable. With the antennas at both ends vertically polarized, and with the
signal generator tuned to a particular test frequency, raise and lower the test antenna to
obtain a maximum reading at the spectrum analyzer. Adjust the level of the signal
generator output until the previously recorded maximum reading for this set of
conditions is obtained. This should be done carefully repeating the adjustment of the
test antenna and generator output.
signal generator tuned to a particular test frequency, raise and lower the test antenna to
obtain a maximum reading at the spectrum analyzer. Adjust the level of the signal
generator output until the previously recorded maximum reading for this set of
conditions is obtained. This should be done carefully repeating the adjustment of the
test antenna and generator output.
EIRP(dBm) = Pg(dBm) – cable loss (dB) + antenna gain (dBd)
where:
Pg is the generator output power into the substitution antenna.
where:
Pg is the generator output power into the substitution antenna.
Pre-test the 3 modulation to find 8DPSK is worse case, so only record 8DPSK test data.
Report No.: EM201300471-1 Application No.:
ZJ00032008 Page 51 of 57
5.1.3 TEST SETUP
Below 1GHz
Above 1GHz
EUT
Ground Plane
3 m
1.5
m
m
Cable
Test table & Turntable
1m
EMI
Receiver
EUT
Ground Plane
3 m
1.5 m
Cable
Test table & Turntable
1m ~ 4m
EMI
Receiver
Report No.: EM201300471-1 Application No.:
ZJ00032008 Page 52 of 57
5.1.4 TEST RESULTS
30M-1000MHz Spurious Emissions Peak Measurement
No.
Frequency
Reading
Correct
Result
Limit
Margin
Remark
(MHz)
(dBm)
Factor(dB)
(dBm)
(dBm)
(dB)
1
110.4892 -85.59 9.46 -76.13 -57.00
-19.13
Vertical
2
122.9389 -78.30 8.80 -69.50 -57.00
-12.50
Vertical
3
160.1008
-81.61 10.69 -70.92
-57.00
-13.92
Vertical
4
269.9983
-86.33 14.15 -72.18
-57.00
-15.18
Vertical
5
319.5776
-91.65 16.20 -75.45
-57.00
-18.45
Vertical
6
418.5244
-92.05 18.32 -73.73
-57.00
-16.73
Vertical
7
122.9389 -77.77 8.80 -68.97 -57.00
-11.97
Horizontal
8
143.8877 -83.87 9.55 -74.32 -57.00
-17.32
Horizontal
9
160.1008
-81.38 10.69 -70.69
-57.00
-13.69
Horizontal
10
269.9983
-87.02 14.15 -72.87
-57.00
-15.87
Horizontal
11
316.0060
-91.32 15.99 -75.33
-57.00
-18.33
Horizontal
12
418.5244
-91.85 18.32 -73.53
-57.00
-16.53
Horizontal
1000MHz-12750MHz Spurious Emissions Peak Measurement
No.
Frequency
Reading
Correct
Result
Limit
Margin
Remark
(MHz)
(dBm)
Factor(dB)
(dBm)
(dBm)
(dB)
1
1658.723 -74.30 3.63 -70.67 -47.00
-23.67
Vertical
2
3158.946
-78.05 12.56 -65.49
-47.00
-18.49
Vertical
3
3874.694
-73.01 11.48 -61.53
-47.00
-14.53
Vertical
4
8087.627
-79.99 25.74 -54.95
-47.00
-7.95
Vertical
5
9578.959
-77.42 25.04 -52.38
-47.00
-5.38
Vertical
6
12550.658
-80.94 27.08 -53.86
-47.00
-6.86
Vertical
7
1798.417 -77.83 3.45 -74.38 -47.00
-27.38
Horizontal
8
3163.891
-80.23 10.75 -69.48
-47.00
-22.48
Horizontal
9
3845.685
-77.28 12.63 -64.65
-47.00
-17.65
Horizontal
10
5064.985
-78.30 16.93 -61.37
-47.00
-14.37
Horizontal
11
9637.148
-77.95 24.98 -52.97
-47.00
-5.97
Horizontal
12
12445.378
-75.91 25.37 -50.54
-47.00
-3.54
Horizontal
Click on the first or last page to see other AUTHENTICS L8 (serv.man4) service manuals if exist.