Harman Kardon HS 2X0 (serv.man5) Service Manual ▷ View online
27
• To skip to the next or previous MP3 file, press the or
button. To pause play, press the button. To resume play,
press the button again.
• To exit and return to file list screen, press the button.
Playing Videos
Selecting a video file plays the file. If there are other video files in the
folder, the HS 2X0SO/230 will play each one, in order as they appear
on the OSD screen.
If there are other MP3s in the folder with the one that you've selected,
the HS 2X0SO/230 will play each one, in order as they appear on the
OSD screen.
Troubleshooting
If your HS 2X0SO/230 system isn’t performing the way you think it should, check to see if the problem is covered in this section
before calling your dealer or contacting Harman Kardon.
• Check that the receiver’s AC Power Cord is properly plugged into
the receiver’s AC Power Input connector.
• Check that the AC power cord is plugged into a working AC outlet
and that the AC outlet is not controlled by a switch.
• Check that the disc surface is clean and not scratched.
• If you have the receiver’s video output connected to your TV
through your VCR, the copy-protection program on some DVDs
could affect picture quality. Connect the receiver’s video output
directly to your TV’s video input.
• Check the Audio: Settings: Delay menu and change the Delay
setting to put the sound back in sync with the picture.
• Check that the FM antenna is correctly connected.
• Adjust the antenna’s position. If necessary, use a powered
FM antenna or an outdoor FM antenna.
• Replace all three of the remote control’s batteries with fresh ones,
and make sure to install them correctly.
• Hold the remote control closer to the receiver.
• Check that the receiver’s remote sensor is in line of sight with
the remote control. If necessary, use an optional Harman Kardon
HE 1000 external IR receiver.
• Check that you have pressed the remote’s TV or Video button
before trying to operate the component.
• Re-learn the component’s commands into the remote.
• The selected function is not permitted at the time the button
is pressed.
• Unplug the receiver’s power cord from the AC outlet,
wait 30 seconds, then plug it back in.
You can find additional troubleshooting information in the FAQs link
on the Support page at www.harmankardon.com.
• Check the connection between the receiver and the TV.
• Check that the TV is turned on and is set to the proper input source.
• Confirm that all of the choices made in the Settings: Video menu are
correct for your TV.
• If you’re using the HDMI connection, be sure that the TV or video
display is HDCP-compliant. If the TV is not HDCP-compliant,
disconnect the HDMI cable and use the receiver’s S-Video or
composite-video connection.
• Check that the subwoofer’s power cord is plugged into a
working AC outlet.
• Check that the subwoofer’s Power Switch is in the on position.
• Check that the Subwoofer Level Control is not turned all the way
down (fully counterclockwise).
• Check the audio connection between the receiver and the subwoofer.
• Check the receiver’s Settings: Audio: Subwoofer menu to make sure
that the subwoofer volume has not been set at -10dB.
• Check that all input cables are plugged all the way into their
connectors.
• Check that all cables are at least 3m (9.8 ft.) from fluorescent lights.
• Check that all cable connectors are clean. If necessary, wipe them
with a cloth slightly moistened with alcohol.
• Turn the subwoofer’s Power switch off. If the hum goes away,
there is a ground loop between the subwoofer and the receiver.
Plugging the subwoofer’s Power Cord into the same AC outlet that
the receiver is plugged into should eliminate the ground loop.
• Check that the disc is inserted correctly (label-side up).
• Check that the disc is the correct type: DVD, DVD-R, DVD-RW,
DVD+R/RW, VCD, SVCD, CD, CD-R/RW, MP3, WMA (v7 and v8).
Other disc types will not play.
• Check that the disc surface is clean and not scratched.
The receiver won’t power up (the Power Indicator is not lit):
There is noise or other interference in the picture while the HS 280
is playing a DVD:
The sound and picture are out of sync:
The HS 2X0SO/230 cannot tune in radio stations:
The receiver does not respond to remote control commands:
The remote does not control programmed components (TV or Video):
The Ø symbol appears on the screen when you press a remote
control button:
The receiver does not respond to commands, or behaves in an
erratic way:
Sound plays through the HS 2X0SO/230 speakers, but there is no
TV picture:
There is no sound coming from the subwoofer:
There is a constant hum in the sound:
The disc does not play:
harman/kardon
HS 2X0/230 Service Manual
Page 9 of 73
31
Specifications
HS 2X0SO/230 Receiver
Audio Section
Continuous average power, stereo mode (FTC):
65 watts per channel, 120Hz–20kHz,
@ <0.3% THD, both channels driven into 6 ohms
Input sensitivity/impedance (line inputs): 240mV/47k ohms
Frequency response @ 1W (±3dB): 120Hz–20kHz
Transient intermodulation distortion (TIM): <0.2%
FM Tuner Section
Frequency range: 87.5 – 108.0MHz
Usable sensitivity IHF: 3.0μV/14.7 dBf
Signal-to-noise ratio (mono/stereo): 65dB/60dB
Distortion mono/stereo: 0.3%/0.5%
Stereo separation: 40dB @ 1kHz
Selectivity ±400kHz: 65dB
Image rejection: 40dB
IF rejection: 70dB
DVD Player Section
Supported disc formats: 5-inch (12cm) or 3-inch (8cm) DVD Video, DVD-Audio,
standard-conforming DVD-R, DVD+R, DVD-RW, DVD+RW, VCD, CD, CD-R, CD-RW,
MP3 (up to 320kbps bitrate), or WMA (v7-v8) discs
Region code: 2
DVD layers: Single-side/single-layer, single-side/dual-layer, dual-side/dual-layer
Audio formats: Dolby Digital, linear PCM, MP3 (up to 320kbps bit rate),
Windows Media 7 or 8
Still-image format: JPEG
Video signal system: NTSC or PAL
Composite-video output: IV p-p/75 ohms, sync negative polarity
S-Video output: Y/luminance: IV p-p/75 ohms, sync negative polarity;
C/chrominance: 0.3V p-p
Frequency response: DVD (linear PCM): 20Hz–22kHz, ±1.0dB,
CD: 20Hz–22kHz ±1.0dB
Signal-to-noise ratio: 90dB (A-weighted)
Dynamic range: DVD/CD: 92dB (16-bit)
THD/1kHz: DVD/CD: 0.01%
Wow & flutter: Below measurable limits
Video Section
Television format: Automatic or PAL (selectable)
Output level/impedance: 1.0Vp-p/75 ohms
Video frequency response: (composite and S-Video) 10Hz–8MHz (–3dB)
HDMI™ version: 1.2
General
Power requirement: AC 100–240V ~ 50/60Hz
Power consumption: 300W maximum, 1W standby
Dimensions Unit
Shipping
Height
98mm (3-7/8 inches)
197mm (7-3/4 inches)
Width
350mm (13-25/32 inches)
484mm (19-1/16 inches)
Depth
280mm (11 inches) 355mm (14 inches)
Weight: 3.5kg (7.7 lb)
6.1kg (13.4 lb)
Depth measurement includes terminal connections. Height measurement
includes feet and chassis.
Speaker System
Frequency response: 45Hz–20kHz (-6dB)
SAT TS60 Satellites (for HS 280)
Recommended power: 10 ~ 120 watts
Impedance: 8 ohms nominal
Sensitivity: 86dB @2.83V/1 meter
Tweeter: One 19mm (3/4") dome, video-shielded
Midrange: Dual 75mm (3") flat-panel drivers, video-shielded
Dimensions:
Height 299mm (11-25/32 inches)
Width
110mm (4-11/32 inches)
Depth
88mm (3-15/32 inches)
Weight:
1.5kg (3.3 lb)
Height measurement includes removable stands.
SAT-TS11 Satellites (for HS 210)
Recommended power: 10 ~ 120 watts
Impedance: 8 ohms nominal
Sensitivity: 86dB @ 2.83V/1 meter
Tweeter: One 1/2" (12mm) dome, video-shielded
Midrange: Dual 3" (75mm) drivers, video-shielded
Dimensions:
Height 243mm (9-9/16 inches)
Width
100mm (3-15/16 inches)
Depth
92mm (3-5/8 inches)
Weight:
1kg (2.2 lb)
HKTS200SUB Subwoofer
Input rating: AC 220–240V~, 50/60Hz, 200W
Amplifier power: 200 watts RMS
Woofer: 8" cone in a sealed enclosure
External trigger input voltage: 3 ~ 30 volts AC/DC
Dimensions (H x W x D):
Height 353mm (13-29/32 inches)
Width
267mm (10-1/2 inches)
Depth
267mm (10-1/2 inches)
Weight:
9kg (19.8 lb)
Height measurement includes the product’s feet.
Features, specifications and appearance are subject to change without notice.
harman/kardon
HS 2X0/230 Service Manual
Page 10 of 73
harman/kardon
HS 2X0/230 Service Manual
Page 11 of 73
Please note:
Item 18, SMPS Board Assembly has part
number 0209HAV08P6144C2X0.
Item 18, SMPS Board Assembly has part
number 0209HAV08P6144C2X0.
harman/kardon
HS 2X0/230 Service Manual
Page 12 of 73
Click on the first or last page to see other HS 2X0 (serv.man5) service manuals if exist.