DOWNLOAD Harman Kardon HS 2X0 (serv.man2) Service Manual ↓ Size: 6.3 MB | Pages: 70 in PDF or view online for FREE

 

           Page 35 of 69                          Report No.: SH10011244-002 

IEC/EN 60065 

Clause 

Requirement – Test 

Result - Remark 

Verdict 

 

TRF No:  TTRF_IECEN 60065I 

       TRF originator Intertek ETL SEMKO shanghai 

 

IEC 60065, 7

th

 ed.  (EN 60065: 2002)  GROUP DIFFERENCES, NATIONAL DEVIATIONS AND SPECIAL 

NATIONAL CONDITIONS IN THE CENELEC COUNTRIES 

C = CENELEC COMMON MODIFICATIONS 

S = SPECIAL NATIONAL CONDITIONS 

A = A-DEVIATIONS (NATIONAL DEVIATIONS) 

 CONTENTS 

 

C: Add the following annexes:  

Annex ZA (normative) Other international 
publications quoted in this standard with the 
references of the relevant European publications 

Annex ZB (normative) Special national conditions 

Annex ZC (informative) A-deviations 

 Pass 

3.1 

C: Add the following indent at the end of the list:  

-exposure to excessive sound pressures from 
headphones or earphones.  

NOTE A new method of measurement is described 
in EN 50332-1, Sound system equipment: 
Headphones and earphones associated with 
portable audio equipment − Maximum sound 
pressure level measurement methodology and 
limit considerations − Part 1: General method for 
“one package equipment”, and in EN 50332-2, 
Sound system equipment: Headphones and 
earphones associated with portable audio 
equipment − Maximum sound pressure level 
measurement methodology and limit 
considerations − Part 2: Guidelines to associate 
sets with headphones coming from different 
manufacturers. 

Added  

N/A 

4.1.1 

C: Replace the text of the note  

by: NOTE For ROUTINE TEST reference is made 
to EN 50333. 

Replaced  

N/A 

5.1 i) 

C: Add the following note:  

NOTE For RATED POWER CONSUMPTION 
measurements of TVs reference is made to EN 
60107. 

Added  

N/A 

 

           Page 36 of 69                          Report No.: SH10011244-002 

IEC/EN 60065 

Clause 

Requirement – Test 

Result - Remark 

Verdict 

 

TRF No:  TTRF_IECEN 60065I 

       TRF originator Intertek ETL SEMKO shanghai 

 

6.1 

C: Replace the entire subclause by:  

Apparatus including a potential source of ionizing 
radiation shall be so constructed that personal 
protection against ionizing radiation is provided 
under normal operating conditions and under fault 
conditions.  

Compliance is checked by measurement under the 
following conditions:  

In addition to the normal operating conditions, all 
controls adjustable from the outside BY HAND, by 
any object such as a tool or a coin, and those 
internal adjustments or pre-sets which are not 
locked in a reliable manner, are adjusted so as to 
give maximum radiation whilst maintaining an 
intelligible picture for 1 h, at the end of which the 
measurement is made.  

NOTE Soldered joints and paint lockings are 
examples of adequate locking.  

The amount of ionizing radiation is regulated by 
European Council Directive 96/29/Euratom of 13 
May 1996. This directive requires that at any point 
10 cm from the outer surface of the apparatus, the 
dose-rate shall not exceed 1µSv/h (0,1 mR/h) 
taking account of the background level.  

Moreover, the measurement shall be made under 
fault conditions causing an increase of the high-
voltage, provided an intelligible picture is 
maintained for 1 h, at the end of which the 
measurement is made. 

A picture is considered to be intelligible if the 
following conditions are met: - a scanning 
amplitude of at least 70 % of the usable screen 
width; - a minimum luminance of 50 cd/m² with 
locked blank raster provided by a test generator; - 
a horizontal resolution corresponding to at least 
1,5 MHz in the centre, with a similar vertical 
degradation; - not more than one flashover per 5 
min. 

Replaced   

N/A 

13.3.1 

C: Delete note 4. 

Deleted  

Pass 

14 

C: Delete note 4 and note 5. 

Deleted  

Pass 

15.1.1 

C: Delete note 1 and note 2. 

Deleted  

Pass 

15.2 

C: Delete note 2. 

Deleted  

Pass 

16.1 

C: Delete note 1. 

Deleted  

Pass 

16.2 

C: Delete the note. 

Deleted  

Pass 

20 

C: Delete note 2. 

Deleted  

Pass 

 

           Page 37 of 69                          Report No.: SH10011244-002 

IEC/EN 60065 

Clause 

Requirement – Test 

Result - Remark 

Verdict 

 

TRF No:  TTRF_IECEN 60065I 

       TRF originator Intertek ETL SEMKO shanghai 

 

Annex B 

C: Replace note 1 by: In the CENELEC countries 
listed in IEC 62151, special national conditions 
apply. 

Replaced  

N/A 

Annex G 

C: Delete the note. 

Deleted  

N/A 

Annex J.2  C: Delete the notes of Table J.1 

Deleted  

N/A 

Annex N 

C: Add after the introduction: For ROUTINE TEST 
reference is made to EN 50333. 

Added  

N/A 

 

 

           Page 38 of 69                          Report No.: SH10011244-002 

IEC/EN 60065 

Clause 

Requirement – Test 

Result - Remark 

Verdict 

 

TRF No:  TTRF_IECEN 60065I 

       TRF originator Intertek ETL SEMKO shanghai 

 

Biblio-
graphy 

C: Add the following standards:  

EN 50332-1:2000, Sound system equipment: 
Headphones and earphones associated with 
portable audio equipment − Maximum sound 
pressure level measurement methodology and 
limit considerations − Part 1: General method for 
“one package equipment”.   

prEN 50332-2 (under consideration), Sound 
system equipment: Headphones and earphones 
associated with portable audio equipment − 
Maximum sound pressure level measurement 
methodology and limit considerations − Part 2: 
Guidelines to associate sets with headphones 
coming from different manufacturers. 

C: Add the following notes for the standards 
indicated:  

IEC 60130           NOTE    Parts 9 and 17:1998 are 
harmonized as Ens (not modified).  

IEC 60169           NOTE    Partly harmonized in the 
EN 60169/HD 134 series (not modified).  

IEC 60173           NOTE    Harmonized as HD 27 
S1:1978 (not modified).  

IEC 60335-2-56   NOTE    Harmonized as EN 
60335-2-56:1997 (not modified).  

IEC 60335-2-82   NOTE    Harmonized as EN 
60335-2-82:2000 (not modified).  

IEC 60695           NOTE    Harmonized as EN 
60695 series (not modified).  

IEC 61040           NOTE    Harmonized as EN 
61040:1992 (not modified).  

IEC 61558-2-1     NOTE    Harmonized as EN 
61558-2-1:1997 (not modified).  

IEC 61558-2-4     NOTE    Harmonized as EN 
61558-2-4:1997 (not modified).  

IEC 61558-2-6     NOTE    Harmonized as EN 
61558-2-6:1997 (not modified). 

 N/A