View Harman Kardon GO AND PLAY MINI Service Manual online
Northridge, California 91329
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings.Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including
third prong is provided for your safety. If the provided plug does not ﬁt into your outlet, consult an electrician for
replacement of the obsolete outlet.
12. Use only with the cart, stand, tripod, bracket or table speciﬁed by the manufacturer or sold with the
injury from tip-over.
14. Refer all servicing to qualiﬁed service personnel. Servicing is required when the apparatus has been damaged
apparatus, or the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped.
18. Do not expose batteries to excessive heat such as sunshine, ﬁre or the like.
Receive RF Energy:
is subject to the following two conditions: (1) This device
may not cause harmful interference; and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio
or television reception, which can be determined by turning
the equipment off and then on, the user is encouraged to try
to correct the interference by one or more of the following
• Increase the separation between the equipment and
by Harman could void the user’s authority to operate the
003. Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
norme NMB-003 du Canada.
That Can Use an External Antenna:
product, be certain that it is grounded so as to provide some
protection against voltage surges and static charges. Section
810 of the National Electrical Code, ANSI/NFPA No. 70-1984,
provides information with respect to proper grounding of the
mast and supporting structure, grounding of the lead-in wire
to an antenna discharge unit, size of grounding conductors,
location of antenna discharge unit, connection to grounding
electrodes and requirements of the grounding electrode.
installer’s attention to article 820-40 of the NEC, which
provides guidelines for proper grounding and, in particular,
speciﬁes that the cable ground shall be connected to the
grounding system of the building, as close to the point of
cable entry as possible.
to the laser beam, do not open the cabinet enclosure or defeat
any of the safety mechanisms provided for your protection.
DO NOT STARE INTO THE LASER BEAM. To ensure proper use
of this product, please read the owner’s manual carefully and
retain it for future use. Should the unit require maintenance
or repair, please contact your local Harman Kardon service
center. Refer servicing to qualiﬁed personnel only.
Replace only with the same or equivalent type.
Rechargeable batteries (i.e., nickel cadmium, nickel metal-
hydride, lithium and lithium-ion) are considered hazardous
household materials and may pose an unnecessary health
and safety risk.
dispose of any battery with household trash. All batteries
must be disposed of in an environmentally sound manner.
Contact your local waste management ofﬁcials for information
regarding the environmentally sound collection, recycling and
disposal of used batteries.
control, reverse the procedure described for inserting
batteries in the owner’s manual.
the product, removal may not be possible for the user. In this
case, recycling or recovery centers handle the dismantling of
the product and the removal of the battery. If, for any reason, it
becomes necessary to replace such a battery, this procedure
must be performed by authorized service centers.
WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF UNINSULATED
“DANGEROUS VOLTAGE” WITHIN THE PRODUCT’S
ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO
CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
TRIANGLE IS INTENDED TO ALERT THE USER TO
THE PRESENCE OF IMPORTANT OPERATING AND
MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE PRODUCT.
SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR