View Harman Kardon AVR 171S (serv.man3) Service Manual online
REAR PANEL CONNECTORS
REMOTE CONTROL FUNCTIONS
or play audio in response to an AirPlay stream from a networked device (AVR 1710/
AVR 171 only). When the AVR is off, pressing the Power button turns it on. To turn
the AVR off when it is on, press the Power button for more than three seconds. The
Front-Panel Display will indicate “Your device is switched off” for two seconds, then
will switch off.
the off mode after it has been in the Sleep mode for a certain period of time. See
System Settings, on page 34.
AVR to automatically turn on and play audio in response to an AirPlay or DLNA
DMR stream from a networked device (AVR 1710/AVR 171 only). When the AVR is
in Sleep, pressing the Power button turns it on. To put the AVR into Sleep when it is
on, press the Power button for less than three seconds. The front-panel display will
indicate “Device sleep” while the AVR is in the Sleep mode.
signal or user control input , unless USB, iPod, Home Network, vTuner, AirPlay, or
DLNA DMR is active. In these cases, the AVR will automatically enter the Sleep mode
after the number of hours set in the Auto Power Off system setting. See System
Settings, on page 34.
jack for private listening. This jack is also used to connect the supplied microphone for
the EzSet/EQ setup procedure described in Conﬁgure the AVR For Your Speakers, on
between the manual (one frequency step at a time) and automatic (seeks frequencies
with acceptable signal strength) FM tuning mode. The button also toggles the radio
between stereo and mono modes when an FM station is tuned in.
broadcasts RDS information, this button activates the various RDS functions.
device inserted into the port. Insert the connector or device into the USB port oriented so
it ﬁts all the way into the port. You may insert or remove the connector or device at any
time – there is no installation or ejection procedure.
operating system is released in the future, you will be able to download it to the AVR
using this port. Complete instructions will be provided at that time.
may damage both the AVR and the other device.
level adjustment. After pressing this button, use the Up/Down buttons/Tuning buttons to
select the channel for adjustment and use theLeft/Right buttons to adjust the channel’s
source. Use the Left/Right buttons to cycle through the available input connections, and
press the Set button to assign the currently-displayed connection to the source.
sure that the sensor is not blocked.
commands and changes in the incoming signal. In normal operation, the current source
name appears on the upper line, while the active surround mode is displayed on the
lower line. When the on-screen display menu system (OSD) is in use, the current menu
When the radio is the active source, use these buttons to tune stations according to the
setting of the Tuning Mode button (see above).
category. Each press changes the surround-mode category: Auto Select, Virtual, Stereo,
HARMAN NSP, Movie, Music and Video Game. To change the speciﬁc surround-sound
mode within the category, use the Surround Mode Select buttons. See Audio Processing
and Surround Sound, on page 29, for more information about surround modes.
category, press these buttons to select a speciﬁc mode within the category, such as to
change from Dolby
analog, and the number of channels encoded within the signal.