JBL ON BEAT XTREME Service Manual ▷ View online
JBL
Service Manual
OnBeat Xtreme
Docking station for iPod, iPad, iPhone.
Released EU2012
Harman International
Rev , 0/2013
8500 Balboa Boulevard
ESD WARNING
2
OWNER’S MANUAL
3
EXPLODED VIEW AND PARTS
16
PARTS LIST
17
SCHEMATIC DIAGRAMS
25
SERVICE BULLETIN: iPod 30-PIN
CONNECTOR BOARD EXCHANGE
30
SOFTWARE UPDATE PROCEDURE
32
CONTENTS
Each precaution in this manual should be followed during servicing.
Components identified with the IEC symbol
in the parts list are special significance to safety. When replacing a component identified with
, use only the replacement parts designated, or parts with the same ratings or resistance, wattage, or voltage that are designated in the
parts list in this manual. Leakage-current or resistance measurements must be made to determine that exposed parts are acceptably
insulated from the supply circuit before retuming the product to the customer.
Some semiconductor (solid state) devices can be damaged easily by static electricity. Such components commonly are called
Electrostatically Sensitive (ES) Devices. Examples of typical ES devices are integrated circuits and some field effect transistors and
semiconductor "chip" components.
The following techniques should be used to help reduce the incidence of component damage caused by static electricity.
1. Immediately before handling any semiconductor component or semiconductor-equipped assembly, drain off any electrostatic charge on
your body by touching a known earth ground. Alternatively, obtain and wear a commercially available discharging wrist strap device,
which should be removed for potential shock reasons prior to applying power to the unit under test.
2. After removing an electrical assembly equipped with ES devices, place the assembly on a conductive surface such as aluminum foil, to
prevent electrostatic charge build-up or exposure of the assembly.
3. Use only a grounded-tip soldering iron to solder or unsolder ES devices.
4. Use only an anti-static solder removal device. Some solder removal devices not classified as "anti-static" can generate electrical charges
sufficient to damage ES devices.
5. Do not use freon-propelled chemicals. These can generate electrical change sufficient to damage ES devices.
6. Do not remove a replacement ES device from its protective package until immediately before you are ready to install it. (Most replacement
ES devices are packaged with leads electrically shorted together by conductive foam, aluminum foil or comparable conductive material.)
7. Immediately before removing the protective material from the leads of a replacement ES device, touch the protective material to the
chassis or circuit assembly into which the device will be installed.
Be sure no power is applied to the chassis or circuit, and observe all other safety precautions.
8. Minimize bodily motions when handling unpackaged replacement ES devices. (Otherwise harmless motion such as the brushing together
or your clothes fabric or the lifting of your foot from a carpeted floor can generate static electricity sufficient to damage an ES devices.
CAUTION :
JBL
OnBeat Xtreme service manual
Page 2 of 33
Owner’s Manual
Bluetooth
®
speaker dock for iPod/iPhone/iPad
JBl
®
OnBeat XtreMe
™
JBL
OnBeat Xtreme service manual
Page 3 of 33
2
IntrOductIOn
The JBL
®
OnBeat Xtreme
™
speaker dock provides the ultimate in high-
quality sound for your iPod, iPhone, iPad or other Bluetooth
®
-enabled
devices. Built-in Bluetooth technology lets you play and control your
music wirelessly from anywhere within a 30-foot radius. You can
wirelessly stream high-quality audio and even handle phone calls. The
JBL OnBeat Xtreme unit’s rotating dock connector lets you orient your
iPod, iPhone, or iPad device with its screen in portrait or landscape
mode, and the included USB cable connects the JBL OnBeat Xtreme
dock to your computer so you can charge and synchronize your iPod,
iPhone, or iPad device with your iTunes library.
Compatibility
The JBL OnBeat Xtreme system is compatible with most Bluetooth-
The JBL OnBeat Xtreme system is compatible with most Bluetooth-
enabled devices, music players, cell phones and laptops. Enabled with
Bluetooth A2DP (Advanced Audio Distribution Profile), AVRCP (Audio/
Video Remote Control Profile) and HFP (Hands-Free Profile), the system
can stream high-quality sound and serve as a speakerphone. The stereo
Aux connection also lets you enjoy high-quality audio from a variety of
devices such as MP3 and CD players, desktop computers (all platforms),
laptops and satellite radio tuners.
Included IteMs
Carefully unpack your speaker dock, and confirm that all the items
shown here are included: JBL OnBeat Xtreme speaker dock, AC power
cord*, remote control, iPod touch/iPhone adapter clip, iPad adapter clip
and USB cable.
*AC cord varies by region
cOnnectIOns
attaCh the ipod/iphone/ipad adapter Clip
Your JBL OnBeat Xtreme speaker dock includes two adapter clips: one
Your JBL OnBeat Xtreme speaker dock includes two adapter clips: one
for an iPod touch/iPod classic/iPhone device, and another for an iPad
device (
Note: iPod nano models do not require an adapter clip.)
Attach the appropriate adapter clip to the JBL OnBeat Xtreme unit as
shown below. Rotate the rubber end caps as shown to accommodate
different model iPad devices and units with third-party skins.
iPod touch/iPhone
Bend Clip
Slightly
Bend Clip
Slightly
For iPad 2 with Smart Cover and
for Units with Third-Party Skins
iPad
For iPad 1
For iPad 2
JBL
OnBeat Xtreme service manual
Page 4 of 33